Denon AVR-686S Connecting Other Sources

ENGLISH

Connecting Other Sources

Cable indications

The hookup diagrams on the subsequent pages assume the use of the following optional connection cables (not supplied).

		Audio cable			Video cable
A	Analog terminal (Stereo)			F	Video terminal
	(White)	L	L	(Yellow)
	(Red)
		R	R		Video cable (75 Ω
		Pin-plug cable				/ohm video pin-plug cable)
B	Analog terminal (Monaural, for subwoofer)			G	S-Video terminal
		Pin-plug cable			S-Video cable
C	Digital terminal (Coaxial)			H	Component video terminal
	(Orange)				(Green)	(Y)

Connecting Other Sources

The video conversion function

With the AVR-686, the Video signal and the S-Video signal which were inputted are mutually converted. And also the Video signal and the S-Video signal which were inputted are converted into a higher quality.

The flow of the video signals.

(Component video	(Component video
terminals)	terminals)
(S-Video terminal)	(S-Video terminal)
(Video terminal)	(Video terminal)
This unit’s input	This unit’s output
terminals	terminals

Cautions on the video conversion function:

Coaxial cable (75 Ω /ohm pin-plug cable)

(Blue) (PB/CB)

When the component video terminals are used to connect the AVR-686 with a TV (or monitor, projector, etc.) and the video

D		(Red)				(PR/CR)
	Digital terminal (Optical)		Component video cable
				Signal direction
	Optical cable (Optical fiber cable)	Audio signal
E	Speaker terminal		IN	OUT	OUT	IN
		Video signal
			IN	OUT	OUT	IN
	Speaker cable

NOTE:

•Do not plug in the power supply cord until all connections have been completed.

•When making connections, also refer to the operating instructions of the other components.

•Be sure to connect the left and right channels properly (left with left, right with right).

•Note that binding pin-plug cables together with power supply cords or placing them near a power transformer will result in hum or other noise.

(yellow) or S-Video terminals are used to connect the AVR-686 with a VTR, depending on the combination of the TV and VTR the picture may flicker in the horizontal direction, be distorted, be out of sync not display at all when playing video tapes.

If this happens, connect a commercially available video stabilizer, etc., with a TBC (time base corrector) function between the AVR-686 and the VTR, or if your VTR has a TBC function, turn it on.

11

ENGLISH