ENGLISH
Basic Operation
Basic Operation
Playback using the external input (EXT. IN) terminals
Playback
INPUT MODE | ANALOG | MASTER VOLUME | |||
| FUNCTION | DIMMER STATUS |
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| VIDEO SELECT |
|
|
|
| ||
MAIN |
|
|
| EXT. IN |
|
|
| SELECT | ||||||
| PHONES |
|
| SPEAKER | SURROUND |
| MODE | |||||||
Playing the input source
1 Select the input source to be played.
Example: CD
(Main unit) | (Remote control unit) |
To select the input source when ZONE2/REC OUT is selected, press the MAIN button, then operate the input function selector.
2 Select the play (surround) mode.
Example: STEREO
| SELECT |
(Main unit) | (Remote control unit) |
To select the surround mode while adjusting the surround parameters, tone defeat or tone control, press the SURROUND MODE button and then operate the selector.
SURROUND
MODE
FUNCTION
| VOLUME |
| MUTING |
ON SCREEN | DIMMER |
VIDEO SELECT | SPEAKER |
INPUT MODE | EXT. IN |
| ANALOG |
3 Start playback on the selected component.
For operating instructions, refer to the component’s manual.
4 Adjust the volume.
| The volume level is |
| displayed on the |
| master volume level |
(Main unit) | (Remote control unit) display. |
The volume can be adjusted within the range of
is set as described ( 
page 29), if the volume for any channel is set at +0.5 dB or greater, the volume cannot be adjusted up to 18 dB. (In this case the maximum volume is adjusted to “18 dB — (Maximum value of channel level)”.)
The signals being input to the external decoder input terminals are played without passing through the surround circuitry.
Press the EXT. IN button to select the external input.
•Canceling the external input mode:
Press the INPUT MODE or ANALOG button to switch to the
desired input mode ( 
page 20, 21).
•The external input mode can be set for any input source. To watch video while listening to sound, select the input source to which the video signal is connected, then set this mode.
•If the subwoofer output level is too high, set the “SW ATT.” surround parameter to “ON”.
NOTE:
•When the input mode is set to the external input (EXT. IN), the play mode (DIRECT PURE DIRECT, VIRTUAL SURROUND, STEREO, STANDARD (DOLBY/DTS SURROUND), 5CH/7CH STEREO or DSP SIMULATION) cannot be selected.
•In play modes other than the external input mode, the signals connected to the EXT. IN terminals cannot be reproduced. In addition, signals cannot be output from channels not connected to the input terminals.
Turning the sound off temporarily (MUTING)
Use this to turn off the audio output temporarily.
Press the MUTING button.
•You can adjust the muting level ( 
page 45).
•Canceling the MUTING mode:
q Press the MUTING button again.
w Press the VOLUME button on the remote control unit, or adjust the volume up or down via the front panel MASTER VOLUME knob.
19
ENGLISH