Easy Setup Procedure

yStarting Auto Setup

Press D H to select “Start”, then press F.

• Start the measurements.

Measurement of each channel is performed as follows:

1

2

FL FR C SW SL

SR SBL SBR

1: The subwoofer speaker is measured twice.

2: Not displayed when “ZONE2” and “Front” are set at “Setting the

Power Amplifier Assignment” (

page 58).

After each channel is measured, “Calculating” appears.

The display switches to the Auto Setup check screen automatically.

e

NOTE:

Do not change the speaker connections or subwoofer volume after making the measurements.

Do not turn off the power while the data is being stored.

Cautions during measurements:

Loud test tones are output during the measurements. Be careful for example when small children are nearby.

Proper measurements may not be possible if there are obstacles between the speaker and the setup microphone.

During the measurements, do not stand between or near the speakers and setup microphone.

To avoid influencing the measurements, turn off the power of air- conditioners or any other equipment producing sound in the room. Perform the measurements with the room as quiet as possible.

Measurement is cancelled when VOLUME is operated while the Auto Setup is performed.

¢About automatic retry

To confirm the results of the measurements, remeasurement is automatically performed.

Remeasurement is performed up to two times. During this time, “Retry1” or “Retry2” is displayed on the screen.

ENGLISH

Easy Setup Procedure

u Checking and storing the measurement results

1 Press D H to select an item, then press ENTER.

The measurement results of each item can be checked here.

2 After checking, press ENTER, then press D H to set.

Store:

All the settings are stored in the memory.

Retry:

Perform the measurement again.

Measurement is repeated.

Cancel:

Cancel the auto setup settings.

3 When “Store” is selected: Press F.

1

h(Press ENTER.)

2

Example: Speaker Configuration Check

When measurements have been made using the measurement microphone, speakers with a built-in filter such as subwoofers might be set with a value that differs from the physical distance because of the internal electrical delay.

12

ENGLISH