Operation

Viewing still pictures and videos

(only for iPods equipped with the slideshow / video function)

Use this procedure to view photo and video data stored on the iPod on a monitor.

1 Press MODE for at least 2 seconds to switch from the Browse mode to the Remote mode.

• “Remote iPod” is displayed on the DRA-297’s display.

2 Watching the iPod’s screen, press [D H] to select “Photos” or “Video”, then press ENTER or [G].

•The iPod’s photo and video data are displayed on the monitor.

•To output photo or video data recorded on the iPod to the monitor, the iPod’s “TV Out” setting (under “Video Settings”) must be set to “ON”.

For details, refer to the iPod’s operating instructions.

Disconnecting the iPod

Press <ON/STANDBY> or [POWER OFF] and set the

DRA-297’s power to the standby mode.

The iPod can be disconnected after switching to a function other than the one to which the iPod input is assigned.

Recording the program source (recording the source currently being monitored)

1 Select the input source to be played.

2 Start recording on the tape or video deck.

For instructions, refer to the component’s operating instructions.

•The AUDIO IN’s signal selected with INPUT SELECTOR are output to the CD-R/TAPE and VCR AUDIO OUT terminals.

¢Simultaneous recording

The signals of the source selected with INPUT SELECTOR are output simultaneously to the CD-R/TAPE and VCR REC OUT terminals. If a total of two tape and/or video decks are connected and set to the recording mode, the same source can be recorded simultaneously on every decks.

ENGLISH

Operation

About the memory functions

¢Last function memory

The various settings set when the DRA-297’s power is switched to standby are stored in the memory. When the power is turned back on, the settings made when the power was switched to standby are recalled.

¢Backup memory

The various settings are stored in the memory for about 1 week, even when the power is turned off or the power cord is unplugged.

Initialization of the microprocessor

If the indication on the display is not normal or if the operation of the unit is not correct, then the microprocessor should be reset by the following procedure.

1 Switch off the unit using <POWER>.

2 Keep both <SPEAKER> (A and B) depressed and turn on the unit by pressing <POWER>.

3 Check that the entire display is flashing at 1-second intervals and release the buttons.

•The microprocessor will be initialized.

•If step 3 does not work, start over from step 1.

•If the microprocessor has been reset, all the button settings are reset to the default values (the values set upon shipment from the factory).

18

ENGLISH