Getting Started Connections Setup Information Troubleshooting
ENGLISH
Personal Memory Plus Function
This function sets the settings last selected for the
individual input sources.
When you switch to an input source, the settings are
automatically set to the ones that were set the last time
that input source was used.
Convenient Functions
Last Function Memory
This stores the settings as they were directly before the
standby mode was set.
When the power is turned back on, the settings are
restored to as they were directly before the standby mode
was set.
Backup Memory
The various settings are backed up for about 1 week,
even if the power is turned off or the power cord is
disconnected.
Auto Power On
When the power is in the standby mode, the power turns
on simply by pressing <1/3>.
Resetting the Microprocessor
Perform this procedure if the display is abnormal or if
operations cannot be performed.
When the microprocessor is reset, all the settings are
reset to their default values.
1Remove the power plug.
2
While pressing <9> and <MUTE / SNOOZE>
simultaneously, plug the power cord into a power outlet.
3When “INITIALIZE” is displayed, release your
ngers from the two buttons.
When “INITIALIZE” is not displayed in step 3, repeat operations from
step 1.
1Set the current time (vpage 8).
2During playback, use SLEEP to select the time.
120 90 60 50 40 30 20 10
b After about 5 seconds, the previous display reappears and the
timer starts.
3The power is set to the standby mode after the set
amount of time.
Off
Setting the Sleep Timer
Use this function to automatically switch the power to the
standby mode after a specific amount of time (minutes).
Canceling the sleep timer
Press SLEEP, select “Off” from the sleep timer time display.
Checking the time remaining until the sleep timer
starts
Press SLEEP.
Checking the current time
Press DISPLAY or hold down DIMMER for 2 seconds or more.
The time is displayed.
Playback