Dayton Operating Instructions and Parts Manual | 3VH22 |
Dayton® Propane
Construction Convection Heater
Incorrect
Flame Pattern–
Flashback
Yellow
Flame
Flame Inside Burner Tube (makes roaring noise)
Maintenance
Never attempt to service heater
while it is connected to propane supply, operating, or hot. Severe burns can occur.
1. | Keep heater clean. |
2. | Inspect heater before each use. Check |
| connections for leaks. Apply mixture of |
| liquid soap and water to connections. |
Blue Flame | Bubbles forming show a leak that must |
| be corrected. Correct all leaks at once. |
3. | Inspect hose/regulator assembly before |
| each use. If hose is highly worn or cut, |
| replace. |
4. | Have heater inspected yearly by a |
| qualified service person. |
Figure 7 - Flame Pattern during Flashback
TO STOP HEATER
1.Tightly close propane supply valve on propane tank(s). Allow heater to burn remaining fuel in hose.
2.Shut off main burner valve. Do this by pushing in the control knob and turning it clockwise to the OFF position.
TO RESTART HEATER
1.Wait five minutes after stopping heater.
2.Restart heater by following steps under To Start Heater, page 5.
Storage
Disconnect heater from propane
supply tank(s).
1.Store propane tank(s) in safe manner. Refer to Chapter 5 of Standard for Storage and Handling of Liquefied Petroleum Gases, ANSI/NFPA 58 and/or CAN/CGA B149.2. Follow all local codes. Always store propane tanks outdoors.
2.Place plastic cover caps over brass fittings on inlet connector and hose/regulator assembly.
3.Store in a dry, clean, and safe place.
6
