Desa CGESBM Listing Approvals, Unpacking And Testing The Unit, Product Dimensions Specifications

Models: CGESBM

1 8
Download 8 pages 13.32 Kb
Page 3
Image 3
Continued

SAFETY INFORMATION

Continued

12.Always disconnect the unit from the power supply before performing any cleaning, light bulb replacement, maintenance, relocating the heater or when the unit is not in use for long periods of time.

13.When transporting or storing the unit, keep it in a dry location, free from dust, excessive vibration or other factors, which may damage the unit.

LISTING APPROVALS

This heater has been tested in accordance with the CSA Standards for fixed and location-dedicated electric room heaters in the United States. All components are UL or CSA safety certified.

If you need assistance during installation, please con- tact your local dealer or the DESA Heating Products Technical Services Department at 1-866-672-6040.

UNPACKING AND

TESTING THE UNIT

Carefully remove the unit from the box. Prior to permanently installing the unit, test to make sure the unit operates properly by plugging the power supply cord into a conveniently located 120-volt grounded outlet.

LISTING APPROVALS CAUTION: The unit's power supply cord must be connected to a properly grounded and pro- tected 120-volt outlet. Always use ground fault protection where required by the electri- cal code.

UNPACKING AND WARNING: Do not operate the unit if it is damaged or has malfunctioned.Ifyoususpectthe unit is damaged, return the unit to an authorized service facility for examination, electrical or me- chanical adjustment or repair.

PRODUCT DIMENSIONS &

SPECIFICATIONS

19.5"

12.5"

 

19.625"

Figure 1 - Heater Dimensions

Model:

CGESBM

Frequency

60 Hz

Heater Power

1500 W

Heater Output

5000 BTUs

Power Supply

120V; 15 Amp

 

Grounded, Circuit

Note: A dedicated power supply circuit is recom- mended for the unit but not required. Additional electrical appliances on the same circuit may ex- ceed the current (amperage) rating for that circuit. If after the installation of your unit, the circuit breaker trips or the fuse fails on a repeated basis, then a dedicated circuit will likely be required. Any new wiring must be done in compliance with local and national codes and other applicable regula- tions in order to reduce the risk of fire, electric shock or other injuries. Therefore, it is strongly recommended that you hire a licensed electrician to complete any such work.

117191-01A

www.desatech.com

3

Page 3
Image 3
Desa CGESBM Listing Approvals, Unpacking And Testing The Unit, Product Dimensions Specifications, Continued