Instructions For Installing GA2100A Fan Accessory
Carton Contents |
|
• One Fan Accessory | • One #10 Screw (long) |
• One Fan Housing | • Two “U” Nuts |
• Four #8 Screws | • Three Brackets |
• Two #10 Screws |
|
NOTICE
If wall mounted, heater must be disconnected from gas supply and removed from wall before installing fan accessory. Contact a qualified service person to do this. All local codes must be followed.
!WARNING
Fan accessory must be grounded. Fan comes with a
Grounded Outlet
Grounding
Plug
Figure 1 - Grounding Plug
Attaching Fan Accessory
1.Knock out center panel at four tabs with screwdriver (see Figure 2).
2.Position fan housing between fan accessory and heater back panel. Attach fan accessory and fan housing to heater back panel using four #8 screws (see Figure 3).
Center 
Panel
Tab
Figure 2 - Center Panel
Fan | Fan Housing |
Accessory |
|
Wall Mounting Instructions For Models With Mounting Bracket
1.Mount heater to wall by following steps under INSTALLING TO WALL in owner’s manual.
2.Plug power cord of fan into grounded outlet.
3.Discard “U” nuts, brackets, and extra screws provided with fan accessory.
Wall Mounting Instructions For Models With Raised Mounting Holes
After attaching fan accessory, heater must be mounted to wall in different manner than what is specified in owner’s manual. Follow steps below to mount heater to wall.
1.Locate the two raised mounting areas at top of heater back panel. Each area has a square hole in center and a key hole at top (see Figure 4).
Key Hole | Raised |
| Mounting Area |
Square Hole 
Figure 4 - Raised Mounting Areas
2.Insert “U” nut into square hole on each mounting area. Attach “U” nut as illustrated in Figure 5. Push “U” nut into place. Screw hole on “U” nut should be visible through key hole in mounting area.
Screw Hole
“U” Nut
Screw Hole
“U” Nut
Figure 5 - Attaching “U” Nut
Continued on Back
#8 Screw
Figure 3 - Attaching Fan Accessory and Fan Housing
