INSTALLATION
Continued
INSTALLING HEATER TO WALL
Marking Screw Locations
1.Determine where you will locate heater.
WARNING: Maintain minimum clearances shown in Figure 5. If you can, provide greater clearances from floor and joining wall.
2.Mark two mounting screw locations on wall (see Figure 5).
|
| 8 7/8" |
|
|
| 7 3/4" |
|
|
|
|
|
|
|
|
|
|
|
| |||
| Blue Flame |
|
|
|
|
|
| |||
| 10 7/8" Plaque |
|
|
|
|
|
| |||
| Minimum To |
|
|
|
|
|
| |||
|
|
|
|
|
|
| ||||
| Maintain 6" |
|
|
|
|
|
| |||
WALL | Clearance | Mounting | 20 1/4" |
| ||||||
From Wall |
| |||||||||
|
|
|
|
|
|
| ||||
JOINING |
|
|
|
| Screw | Minimum To | ||||
|
|
|
| Locations | ||||||
|
|
|
|
| From Floor | |||||
|
|
|
|
|
|
|
|
| Maintain 3" | |
|
|
|
|
|
|
|
|
| Clearance | |
FLOOR
Figure 5 - Mounting Screw Locations
Installing Two Mounting Screws
Note: Wall anchors and mounting screws are in hardware package. The hardware package is provided with heater.
Attaching to wall stud method
For attaching mounting screw to wall stud
1.Drill hole at marked location using 9/64" drill bit.
2.Insert mounting screw into wall stud.
3.Tighten screw until 1/16" space (thickness of penny) is be- tween screwhead and wall.
Attaching to wall anchor method
Follow instructions below to attach mounting screws to hollow walls (wall areas between studs) or solid walls (concrete or masonry).
1.Drill holes at marked locations using 5/16" drill bit. For solid walls (concrete or masonry), drill at least 1 1/4" deep.
2.Fold wall anchor (see Figure 6).
INSTALLATION | 7 |
Installation Items | |
Locating Heater |
|
Installing Heater To Wall |
|
|
|
3.Insert wall anchor (wings first) into hole. Tap anchor flush to wall.
4.For thin walls (1/2" or less), insert red key into wall anchor. Push red key to “pop” open anchor wings (see Figure 7). IMPORTANT: Do not hammer key! For thick walls (over 1/2" thick) or solid walls, do not pop open wings.
5.Tighten two screws until 1/16" space (thickness of penny) is between screwheads and wall (see Figure 8).
Thin Walls (1/4" to 1/2" thick)
Figure 6 - Folding Anchor | Figure 7 - Popping Open Anchor |
| Wings For Thin Walls |
| Thin or |
| Thick Wall |
| (thick wall |
| shown) |
1/16" |
|
Space |
|
| Solid |
| Wall |
Figure 8 - Tightening Anchors
Placing Heater On Mounting Screws
1.Locate two keyhole slots on back panel of heater (see Figure 9).
2.Place large openings of slots over screwheads. Slide heater down until screws are in small portion of slots.
Keyhole Slots
Figure 9 - Location Of Keyhole Slots On Back Panel Of Heater
For more information, visit www.desatech.com
