Desa operating instructions Remote Operation, ON/OFF Series Models HRC100 and HRC101

Installing 9-Volt Battery (Not Included) in

Hand-Held Remote Control Unit

1. Remove battery cover on back of remote control unit.

2. Remove and discard sensor tag inside battery housing.

3. Attach terminal wires to the battery. Place battery into the battery housing.

4. Replace battery cover onto remote control unit.

Battery	Remote Control Unit
Cover
	Sensor
	Tag
Terminal
Wires
	Battery
	Housing
9-Volt Battery

Figure 4 - Installing Battery in Hand-Held

Remote Control Unit

REMOTE OPERATION

NOTICE: You must light the pi- lot before using the hand-held remote control unit. See Light- ing Instructions in your owner’s manual.

1.After lighting, let pilot flame burn for about one minute. Turn control knob to ON posi- tion. Adjust flame adjustment knob anywhere between HI and LO. Slide the selector switch to the REMOTE position (see Figure 5).

Note: The burner may light if hand-held remote was on when selector switch was last turned off. You can now turn the burner on and off with the hand-held remote control unit.

IMPORTANT: Do not leave the selector switch in the REMOTE or ON position when the pilot is not lit. This will drain the battery.

Selector Switch in

REMOTE Position

(Optional Hand-Held Control Knob

Remote Control)

REMOTE		N		OL
	O
OFF	T
ON	L
	O
	I		O	HI
		P	FF

Flame Adjustment Knob (Available on Some Models)

Figure 5 - Setting the Selector Switch, Control Knob and Flame Adjustment Knob (Available on Some Models) for Hand-Held Remote Operation

ON/OFF Series

(Models HRC100 and HRC101)

Hold the control button on the hand-held remote until burner turns on. Hold the control button again until burner turns off (see Figure 6).

To Lock press both buttons on hand-held remote control until light stops flashing. Hand-held remote control is now locked. If the fire is on it will be turned off automatically. In the locked state, the light will not light up when any button is pressed.

To Unlock press both buttons together on hand- held remote control until the light stops flashing. The hand-held remote is now unlocked.

Indicator Light

Control

Button

Figure 6 - ON/OFF Hand-Held Remote

Control Unit

 www.desatech.com 116710-01C