www.desatech.com
111604-01H 21
OPERATING HEATER
Continued
Figure 36 - Pilot (Propane/LP)
Ignitor
Electrode
Pilot Burner
Figure 37 - Pilot (Natural)
Ignitor
Electrode
Pilot Burner
9. Slightly push in and turn control knob coun-
terclockwise to the ON position.
10.
Press the on/off key on the remote control to
turn on appliance main burner. Wait at least 5
seconds before setting desired flame height.
11. Press the up or down key until the small
triangle is to the left of large flame icon
at the top of LCD display (see Figure 38).
Press the left or right key to set the desired
flame height.
CAUTION: Do not try to ad-
just heating levels by using the
equipment shutoff valve.
TO TURN OFF GAS
TO APPLIANCE
Shutting Off Heater
Press on/off key on remote control and turn
control knob clockwise to the OFF posi-
tion (see Figure 35, page 20).
Shutting Off Burners Only (pilot stays lit)
Press the on/off key on remote control or turn
control knob clockwise to the PILOT
position.
MANUAL LIGHTING
PROCEDURE
1. Follow steps 1 through 7 under Lighting
Instructions, page 20.
2. Depress control knob and light pilot with
match.
3. Keep control knob pressed in for 30 seconds
after lighting pilot. After 30 seconds, release
control knob. Now follow steps 9 through
11 under Lighting Instructions.
HAND-HELD
REMOTE OPERATION
NOTICE: You must light the pilot
before using the hand-held re-
mote control unit. See Lighting
Instructions, page 20.
When the appliance and the remote control are
switched off, the house icon with the room tem-
perature will be displayed. When the remote con-
trol is turned on, other icons will be visible and
the main burner of the appliance will turn on.
1. Turn control knob clockwise to the
ON position (see Figure 35, page 20).
2. Press the ON button on remote control (see
Figure 38). Wait 5 seconds to send a com-
mand to appliance.
Note: An acoustic signal will be heard that
confirms the reception of the command sent
from the remote control.
Setting Flame Height
Press the up or down key until the small triangle
is to the left of large flame icon at the top of LCD
display (see Figure 38). Press the left or right
key to set the desired flame height. Six flame
levels are available from 1 (minimum) to 6
(maximum).
Left and
Right Keys
Increase and
Decrease
Set Points
On/Off
Button
Flame Height
Indicator
Thermometer
Icon
Clock Icon
Figure 38 - Remote Control
Small Triangle
Icon (Function
Indicator)
LCD Display
Room
Temperature
Display
Sleep Timer
Display
Lock-Out
Indicator
Low Battery
Indicator
Up and Down Keys Moves
Placement from Top to
Bottom on LCD Display