2

SAFETY INFORMATION

SAFETY INFORMATION

WARNINGS

WARNING: This product contains and/or generates chemicals known to the State of California to cause cancer or birth defects, or other reproductive harm.

WARNING: FIRE, BURN, INHALATION, AND EX- PLOSION HAZARD. KEEP SOLID COMBUSTIBLES, SUCH AS BUILDING MATERIALS, PAPER OR CARD- BOARD, A SAFE DISTANCE AWAY FROM THE HEATER AS RECOMMENDED BY THE INSTRUC- TIONS. NEVER USE THE HEATER IN SPACES WHICH DO OR MAY CONTAIN VOLATILE OR AIRBORNE COMBUSTIBLES, OR PRODUCTS SUCH AS GASO- LINE, SOLVENTS, PAINT THINNER, DUST PARTICLES OR UNKNOWN CHEMICALS.

WARNING: NOT FOR HOME OR RECREATIONAL VEHICLE USE.

Install and use heater with care. Follow all local ordinances and codes. In the absence of local ordinances and codes, refer to the Standard for Storage and Handling of Liquefied Petroleum Gas, ANSI/NFPA 58 and the Propane Installation Code, CAN/CGA B149.2. This instructs on the safe storage and handling of pro- pane gases.

Use only the electrical voltage and frequency specified on model plate. The electrical connections and grounding of the heater shall follow the National Electric Code, ANSI/NFPA 70 or the Canadian Electrical Code, Part 1.

Electrical grounding instructions — This appliance is equipped with a three-prong (grounding) plug for your protection against shock hazard and should be plugged directly into a properly grounded three-prong receptacle or extension cord.

This product has been approved for use in the Commonwealth of Massachusetts.

Use only the hose and factory preset regulator provided with the heater.

Use only propane gas set up for vapor withdrawal.

Provide adequate ventilation. Before using heater, provide at least a three-square-foot opening of fresh, outside air for each 100,000 Btu/Hr of rating.

The heater is designed for use as a construction heater in accordance with ANSI Z83.7/CGA 2.14. Other standards govern the use of fuel gases and heating products for specific uses. Your local authority can advise you about these. The primary purpose of construction heaters is to provide temporary heating of buildings under construc- tion, alteration or repair. Properly used, the heater provides safe economical heating. Products of combustion are vented into the area being heated.

We cannot foresee every use which may be made of our heaters.

Check with your local fire safety authority if you have questions about heater use.

Other standards govern the use of fuel gases and heat producing products for specific uses. Your local authorities can advise you about these.

Carbon Monoxide Poisoning: Some people are more affected by carbon monoxide than others. Early signs of carbon monoxide poisoning resemble the flu, with headaches, dizziness, and/or nau- sea. If you have these signs, the heater may not be working properly. Get fresh air at once! Check for proper ventilation and have heater serviced.

For indoor use only. Do not use heater outdoors.

Do not use heater in occupied dwellings or in living or sleeping quarters.

Do not use heater in basement or below ground level. Propane gas is heavier than air. If a leak occurs, propane gas will sink to the lowest possible level.

Keep appliance area clear and free from combustible materials, gasoline, paint thinner, and other flammable vapors and liquids.

Do not use heater in areas with high dust content. Dust is combustible.

Minimum heater clearances from combustible materials: Outlet: 8 Ft. Sides: 2 Ft. Top: 6 Ft. Rear: 2 Ft.

Keep heater at least six feet from propane tank(s). Do not point heater at propane tank(s) within 20 feet.

Keep propane tank(s) below 100° F.

Check heater for damage before each use. Do not use a dam- aged heater.

Check hose before each use of heater. If highly worn or cut, replace with hose specified by manufacturer before using heater.

Propane Gas: Propane gas is odorless. An odor-making agent is added to propane gas. The odor helps you detect a propane gas leak. However, the odor added to propane gas can fade. Propane gas may be present even though no odor exists.

Make certain you read and understand all warnings. Keep this manual for reference. It is your guide to safe and proper operation of this heater.

Locate heater on stable and level surface if heater is hot or operating.

Never block air inlet (rear) or air outlet (front) of heater.

Keep heater away from strong drafts, wind, water spray, rain, or dripping water.

Do not leave heater unattended.

Keep children and animals away from heater.

Never move, handle, or service a hot or operating heater. Severe burns may result. You must wait 15 minutes after turning heater off.

For morevisit www..com

102370-01K

Page 2
Image 2
Desa REM100LP, BLP100 owner manual Safety Information

BLP100, REM100LP specifications

Desa BLP100 and REM100LP are two remarkable offerings in the world of advanced sustainable energy solutions, each designed to meet specific needs while promoting environmental responsibility.

The Desa BLP100 is a state-of-the-art battery energy storage system that highlights efficiency and reliability. One of its main features is the integration of lithium-ion technology, accommodating a robust energy capacity. This allows the BLP100 to serve both residential and commercial applications, managing energy storage during low-demand periods and delivering power when needed most. The system is designed for easy scalability, enabling users to expand their storage capabilities as their energy needs grow.

The BLP100 is equipped with intelligent management software that optimizes charging and discharging cycles, ensuring maximum battery life while enhancing overall performance. This technology also provides real-time monitoring and analytics, allowing users to have complete insight into their energy consumption patterns. Safety is paramount in the BLP100; it comes with multiple layers of protection against overcharging, overheating, and short circuits.

On the other hand, the REM100LP is an innovative solar energy solution tailored for users looking to harness renewable energy effectively. Its primary feature is the high-efficiency photovoltaic solar panels, which convert sunlight into electrical energy with low environmental impact. The REM100LP is designed with a compact form factor, making it suitable for a variety of settings, from urban rooftops to remote locations.

Its lightweight design, coupled with durable materials, ensures ease of installation and long-lasting performance under various weather conditions. Additionally, the REM100LP incorporates advanced inverter technology, which optimizes the conversion of direct current (DC) to alternating current (AC), thereby providing stable electricity for various applications.

Both the Desa BLP100 and REM100LP systems are examples of how modern technology can address energy challenges while promoting sustainability. Their commitment to integrating cutting-edge technologies exemplifies the future of energy management, where efficiency, safety, and eco-friendliness are paramount. By adopting these systems, users not only benefit from lower energy costs but also contribute favorably to environmental preservation, making a significant impact in the pursuit of global sustainability goals.