Desa SH-5412 Test And Adjustment, Specifications, On-Time Range, Bottom of Sensor, Maximum Range

TEST AND ADJUSTMENT

❒Turn on the circuit breaker and light switch.

NOTE: Sensor has a 1 1/2 minute warm up period before it will detect motion. When first turned on, wait 1 1/2 minutes.

❒Turn the RANGE control to the mid position and the ON-TIME control to the TEST position.

ON-TIME RANGE

ON-TIME RANGE

10 5 1 TEST		MIN MAX	MIN MAX
10 5	1 TEST
MINUTES

Bottom of Sensor

❒Loosen the clamp screw in the sensor ball joint and gently rotate the sensor.

❒Walk through the coverage area noting where you are when the lights turn on (also, the LED will flash several times when motion is detected).Move the sensor head up, down, or sideways to change the cover- age area. Keep the sensor at least 1" (2.5 cm) away from the lamps.

❒Adjust the RANGE as needed. RANGE set too high may increase false triggering.

❒Secure the sensor head by tightening the clamp screw. Do not overtighten the screw.

Clamp

Screw

Ball

Joint

Aim Sensor

Down for Short

Coverage

Aim Sensor

Higher for Long

Coverage

Avoid aiming the control at:

•Objects that change temperature rapidly, such as heating vents and air conditioners. These heat sources could cause false triggering.

•Areas where pets or traffic may trigger the control.

•Nearby large, light-colored objects reflecting light may trigger the shut-off feature. Do not point other lights at the sensor.

8 ft.	180°
(2.4 m)
70 ft.
(21 m)
Maximum Range	Maximum
	Coverage Angle

The detector is most sensitive to motion across its field of view.

MotionMotion

	Sensor
Least Sensitive	Most Sensitive

❒Set the amount of TIME you want the lights to stay on after motion is detected (1, 5, or 10 minutes).

WARNING: Risk of fire. Do not aim the lamps at a combustible surface within 3 ft. (1 m).

SPECIFICATIONS

Range . . . . . . . . . . . . Up to 70 ft. (21 m) [varies with surrounding temperature].

Sensing Angle . . . . . . Up to 180°

Electrical Load. . . . . . Up to 300 Watt Maximum In- candescent [Up to 150 Watt maximum each lamp holder.]

Power Requirements . 120 VAC, 60 Hz

Operating Modes . . . . TEST, AUTO, and MANUAL

MODE

Time Delay . . . . . . . . 1, 5, 10 minutes Range . . . . . . . . . . . . Adjustable

DESA Specialty Products™ reserves the right to dis- continue products and to change specifications at any time without incurring any obligation to incorporate new features in products previously sold.

598-1158-01 3