Desa TD100A, TD102A, TD104A, TD110A 4

SAFETY	Product
Continued	Identification

Clothing or other flammable materials should not be hung from the heater or placed on or near heater.

Installation and repair should be done by a qualified service per- son. Heater should be inspected before use and at least annually by a qualified service person. More frequent cleaning may be required as necessary. It is imperative that controlcompartments,burners,and circulating air passageways of the heater be kept clean.

CAUTION: The gas pressure regulator provided with this appliance must be used. This regulator is set for an output pressure of 28" W.C. (1 P.S.I.).

22.If replacement is required, use only regula- tor with same setting. See Parts page 13.

23.Use correct pressure specifications, see page 9.

24.Propane/LP gas cylinder is not provided. Use a 20 lb. propane/LP gas cylinder marked propane. The cylinder supply system must be arranged for vapor withdrawal. The cyl- inder used must include a collar to protect the cylinder valve. The cylinder must be provided with a shutoff valve terminating in a propane/LP gas supply cylinder valve outlet specified, as applicable, for connection no. 600 in the Compressed Gas Association’s Limited Standard Cylinder Valve Outlet Con- nection for Propane Small Valve Series.

Gas Light

(Inside Deco

Shroud)

Burner

(Behind Grill)

Control

Knob

	On/Off	Electronic
		Ignitor
	Switch

Cabinet

Base

Assembly

Figure 2 - Outdoor Patio Heater with Light

Unpacking Heater

Check all items for shipping damage. If heater is damaged, promptly inform dealer where you bought heater.

1.Remove first base half from box.

2.Remove top cap, 2 deco light shrouds, top and packaging materials from box. Set parts aside in a safe location.

3.Remove burner assembly from box, leav- ing packaging materials on bottom of as- sembly. Set aside in the upright position.

4.Remove lightpost pieces, cabinet base and tank door from box. Set aside.

5.Remove 6 screws securing grill to burner assembly. Remove second base half from inside burner assembly. Reattach grill to burner assembly.

You should have the following assembly parts:

Top Cap (1), Burner Assembly (1), Cabinet Base (1), Front Base (1), Rear Base (1), Wheel (2), Base Cabinet Door (1), Lightpost Panel (4), Deco Light Shroud (2), Upper Screen (4), Lightpost Top (1), Propane Tank Retention Chain (1), Retention Hook (2), Hardware Package (1) (see pages 10 thru 13).