Assembly
Continued
Burner and lightpost assembly
1. | Locate 4 lightpost panels that are pack- |
| aged together. Assemble 3 of the pieces |
| with 4 screws (H) as shown in Figure 5. |
2. | Place lightpost top over panel assembly |
| aligning screw holes. Attach with 3 screws |
| (H) as shown in Figure 5. |
3. | Pilot light and wiring has been placed |
| inside top of burner assembly for ship- |
| ping. Carefully remove pilot from inside |
| assembly and let wiring and pilot hang |
| down back of assembly. |
4. | Place pilot assembly on top of lightpost |
| top as shown in Figure 6. Attach with |
| 4 screws (H). Check wire connections |
| before proceeding. |
5. | Place lightpost panels and top assembly |
| on top of burner assembly aligning back |
| side of each assembly. See Figure 6. At- |
| tach with 3 screws (H). |
Pilot |
| |
Assembly |
| |
| Screw | |
Lightpost | (H) | |
| ||
Assembly | Open Side | |
| ||
| of Panel | |
Screw (H) | Assembly | |
to Back of | ||
| ||
| Heater | |
Burner | Pilot Light | |
Assembly | Wiring to | |
| Back of | |
| Heater |
Figure 6 - Connecting Lightpost and
Burner Assembly
6. | Attach 4 light shroud screens to light |
| shrouds with 4 screws (F) and 4 nuts (G) |
| each as shown in Figure 7. Only 2 of the |
| 4 screens are shown. |
7. | Place deco light shrouds on top of light- |
| post top (see Figure 7). Make sure fanges |
| are on top. Slide shroud tabs together. |
| Attach to lightpost top with 4 screws (H) |
| through holes in bottom of shroud pieces |
| (see Figure 7). Tighten all screws. |
8. | Attach lightpost top cap to shroud assembly |
| with 4 screws (H) as shown in Figure 7. |
Screw (H)
Lightpost 
Top
Lightpost
Panels
Screw (H)
Figure 5 - Lightpost Panels and Top
Screw (H)
Nut (G)
Screen
Screw (F)
Screw (H)
Lightpost
Top
Lightpost 
Top Cap
Deco
Light
Shroud
Fourth
Lightpost
Panel
Assembly
Figure 7 - Attaching Pilot and Shroud
www.desatech.com122527-01B