FIREPLACE INSTALLATION
Installing Optional Brick Liner Models BL36D(S) and BL36DH(S)
23
FIREPLACE INSTALLATION
Continued
INSTALLING OPTIONAL BRICK LINER MODELS BL36DA(SA) AND BL36DHA(SA)
WARNING: If fireplace has been running, turn off and unplug fireplace. Let cool before installing brick liner.
This brick liner kit is optional. You may purchase brick liner from your local retailer or see Accessories, page 39.
CAUTION: Always handle brick panels with two hands. Do not force brick panels into place. Exces- sive force will break brick panels.
1.Remove top and bottom louvers to allow access to door latches.
2.Unlock door latches and open glass door. See Removing/Re- placing Glass Door, steps 1 and 2 on page 22.
3.If installing brick liner in new fireplace, go to step 4. If install- ing brick liner in an existing fireplace, carefully remove logs, lava rock, and ember material.
4.Remove three screws from deflector shield on the inside top of firebox. Set shield and screws aside.
5.Install rear brick panel first. Rest bottom edge of panel on back edge of grate (see Figure 43).
6.Install left side brick panel by sliding it between the grate and the side of the firebox (see Figure 44).
7.Install the right brick panel using the same method described
8.Replace deflector shield using screws removed in step 4.
9.Follow instructions to install logs, lava rock, and ember material.
10.Close glass door and lock latches on top and bottom of door and replace screen. See Removing/Replacing Glass Door, steps 5 and 6, page 22.
11.Close top and bottom louvers.
Rear Brick Panel
Figure 43 - Installing Rear Brick Panel
Left Side
Brick Panel
Figure 44 - Installing Side Brick Panels
For more
visit www.
.com
