Fireplace
Installation
Continued
4.Remount the new frame at the hinge with five new screws before closing door. This will ensure seating of the gasket.
5.Close glass door frame. Lock latches by placing the bar under the tab on door and pushing down and back on latch (see Figure 37, page 24).
6.Replace screen/rod assembly by reversing step 1.
7.Replace louvers by reversing procedure under Removing Louver Panels, page 24.
Cleaning Glass Door
See Cleaning and Maintenance on page 30.
Installing lava rock and glowing embers
It is very important to keep logs exactly as installed. Do not modify logs. Only use log set designed for this fireplace. Logs under log/grate assembly are attached to burner. Do not attempt to move these logs as this will damage logs.
3.Close glass door, lock door latches, replace screen and close louvers (see Removing Glass Door, steps 5 through 7).
WARNING: The glass door must be securely in place before running this fireplace. Do not run this fireplace if glass is missing or broken.
Plenum
Ember Material
Figure 38 - Placing Ember Material on
Burner
Installing Brick liner Models BL42DA(SA) and BL42DHA(SA)
WARNING: Logs are unitized and attached to the grate. Do not handle log/grate assembly by logs. Always pick up by grate.
Open louvers, remove screen, unlock door latches and open glass door. See Removing Glass Door, steps 1 and 2, page 24.
1.Pull ember material apart into pieces no larger than a dime. Place these pieces loosely and spar- ingly directly onto the exposed front section of the burner (see Figure 38). This will create the glowing ember appearance as the flame touches the ember material. Do not block air slots by using too much ember material in one area. It is not necessary to use all of the ember material provided.
2.Pour lava rock onto plenum but not onto flat burner. It is not necessary to use all of the lava rock provided.
NOTICE: Do not put lava rock on burner or under burner. Placing lava rock on burner will cause performance problems.
WARNING: If fireplace has been running, turn off unit. Let cool before installing brick liner.
You may purchase brick liner from your local retailer or see Accessories, page 35.
CAUTION: Always handle brick panels with two hands. Do not force brick panels into place. Excessive force will break brick panels.
1.Remove top and bottom louvers to allow ac- cess to door latches.
2.Unlock door latches and open glass door. See Removing Glass Door, steps 1 and 2, page 24.
3.Carefully remove lava rock and ember material.
4.Remove and iron assembly from plenum by removing screws.
5.Carefully lift logs and ember pod from burner
6.Remove screws that attach plenum to burner to remove plenum.
www.desatech.com | 25 |
