Desa VYM27NR Operating Heater, For Your Safety Read Before Lighting, Instructions

VANGUARD FLAME MAX®

UNVENTED NATURAL GAS LOG HEATER

OPERATING

HEATER

FOR YOUR SAFETY

READ BEFORE

LIGHTING

WARNING: If you do not fol- low these instructions exactly, a fire or explosion may result caus- ing property damage, personal injury or loss of life.

A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.

B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

•Do not try to light any appliance.

•Do not touch any electric switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

•If you cannot reach your gas sup- plier, call the fire department.

C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service technician or gas supplier. Force or attempted repair may result in a fire or explosion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been un- der water.

		LIGHTING		WARNING: Burner will come
		INSTRUCTIONS
				on automatically within one
		WARNING:		minute when the selector switch
				is in the ON position after the
•	If fireplace has glass doors,			pilot is lit.
	never operate this heater with
			4.	Press in and turn control knob clock-
	glass doors closed. If you op-
				wise	to the OFF position.
	erate heater with doors closed,
	heat buildup inside fireplace		5.	Wait five (5) minutes to clear out any
	will cause glass to burst. Also			gas. Then smell for gas, including
	if fireplace opening has vents			near the floor. If you smell gas,
	at the bottom, you must open			STOP! Follow “B” in the safety in-
	the vents before operating			formation, column 1. If you don’t
	heater.			smell gas, go to the next step.
•	You must operate this heater		6.	Press in and turn control knob coun-
	with a fireplace screen in place.
				terclockwise	to the PILOT
	Make sure fireplace screen is
				position. Press in control knob for
	closed before running heater.
				five (5) seconds (see Figure 20).
				Note: You may be running this
NOTICE: During initial operation
				heater for the first time after hook-
of new heater, burning logs will
				ing up to gas supply. If so, the con-
give off a paper-burning smell.
				trol knob may need to be pressed in
Open damper or window to vent
				for 30 seconds or more. This will al-
smell. This will only last a few
				low air to bleed from the gas system.
hours.
			7. With control knob pressed in, press
Note: Home owners generally prefer to
				and release ignitor button. This will
operate their heater with the chimney
				light pilot. The pilot is attached to the
damper closed. This will put all the heat
				front burner. If needed, keep press-
into the room. However, there may be
				ing ignitor button until pilot lights.
times you will desire the full flames of the
				Note: If pilot does not stay lit, con-
High heat setting but will find the heat
output excessive. You can open the chim-				tact a qualified service person or gas
ney damper (if you have one) fully or				supplier for repairs. Until repairs are
partially to release some of the heat.				made, light pilot with match. To light
				pilot with match, see Manual Light-
		WARNING: Damper handle		ing Procedure on page 15.
will be hot if heater has been
running.

1.STOP! Read the safety information, column 1.

2.Make sure manual shutoff valve is fully open.

3.Set switch to OFF position.

	Flame Adjustment Knob
		IH	Control Knob
AUTO			O
OFF			F
ON		N	F
		O	P
		LO	LI
			TO

Ignitor Button Selector Switch in OFF Position

Figure 20 - Control Knob and Ignitor Button Location (Shown as Supplied, No Control Options)

14 104674