![](/images/new-backgrounds/1058479/584797x1.webp)
7. If mantel trim that came with your fireplace has not yet |
been assembled, see Assembling Perimeter Trim. Place |
Slot
Set Screws
metal trim on shoulder screws. Firmly snap trim assembly |
over shoulder screws on fireplace. |
Adjusting
Plate
Top Trim
8. Carefully push mantel and base into position against |
wall. |
Mitered Edge
Assembling Perimeter Trim (If Supplied with Gas Fireplace)
Shim
Side Trim
1.Remove packaging from three pieces of metal trim.
2.Locate two adjusting plates with set screws, and two shims in the hardware packet.
3.Align shim under adjusting plate as shown in Figure 7.
4.Slide one end of adjusting plate/shim in slot on mitered edge of top trim (see Figure 7).
5.Slide other end of adjusting plate/shim in slot on mitered edge of side trim (see Figure 7).
6.While firmly holding edges of trim together, tighten both set screws on the adjusting plate with slotted screw- driver.
7.Repeat steps 2 through 6 for other corner.
Slot
Figure 7 - Assembling Trim
Electric Fireplace Installation
This mantel can be used with Dimplex 32" Electric Fireplace. Electric fireplaces install from the front of mantel. To install electric fireplace see fireplace instruction manual. Use cau- tion when positioning fireplace on base. Base may scratch easily.
2701 Industrial Drive |
| |
P.O. Box 90004 |
| |
Bowling Green, KY | ||
www.desatech.com | ||
Rev. B | ||
05/07 | ||
|