Gas Fireplace Installation
1.Fireplace should be fully assembled. See Assembling Fireplace in fireplace owner’s manual.
2.Place mantel base close to installation location. See fire- place owner’s manual for installation clearances. Leave enough room to insert fireplace from back of mantel.
3.Install gas line. See Connecting to Gas Supply in fireplace owner’s manual. Remember to leave access to the gas shutoff valve somewhere on the base or where it is ac- cessible to the user.
4.Check for leaks. See Checking Gas Connections in fire- place owner’s manual.
5.Position fireplace inside mantel (see Figure 6). Carefully position gas lines. Important: Use caution when position- ing fireplace on base. Base may scratch easily. Make sure fireplace is in proper position within mantel opening before continuing with installation.
6.Fireplace with louver door: Lower bottom louver door. Use two screws provided in hardware package and attach fireplace to wooden base. Close louver door.
Fireplace with fixed louver: Before installing logs or burner assembly (see owner’s manual) remove screws securing floor to assembly. Lift floor for access to bottom of fireplace. Use two screws provided in fireplace hardware package and attach fireplace base to wooden base. Reinstall floor with screws removed previously.
7.If mantel trim has not yet been assembled, see As- sembling Perimeter Trim. Place metal trim on shoulder screws. Firmly snap trim assembly over shoulder screws on fireplace.
8.Carefully push mantel and base into position against wall.
Assembling Perimeter Trim
1.Remove packaging from three pieces of metal trim.
2.Locate two adjusting plates with set screws, and two shims in the hardware packet.
3.Align shim under adjusting plate as shown in Figure 7.
4.Slide one end of adjusting plate/shim in slot on mitered edge of top trim (see Figure 7).
5.Slide other end of adjusting plate/shim in slot on mitered edge of side trim (see Figure 7).
6.While firmly holding edges of trim together, tighten both set screws on the adjusting plate with slotted screw- driver.
7.Repeat steps 2 through 6 for other corner.
Slot
Set Screws
Adjusting Plate
Top Trim
Mitered Edge
Shim 
Side Trim
Figure 6 - Installing Fireplace
Slot
Figure 7 - Assembling Trim
DESA Heating, LLC |
|
2701 Industrial Drive |
|
P.O. Box 90004 | |
Bowling Green, KY | Rev. A |
www.desatech.com | 06/07 |