
Product Identification
Log Set
Burner
Piezo
Ignitor
Control Knob
Base Grate
Figure 1 -
(Logs May Vary by Model, Seasonal Oak Single Burner Model Shown)
Local Codes
Install and use heater with care. Follow all local codes. In the absence of local codes, use the latest edition of The National Fuel Gas Code, ANSI Z223.1/NFPA 54*.
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
Note: Where listed vented decorative logs are re- quired, thermostat operation is not permitted.
State of Massachusetts: The installation must be made by a licensed plumber or gas fitter in the Commonwealth of Massachusetts.
Sellers of unvented propane or natural
Unpacking
CAUTION:Donotremovethe data plates from the grate as- sembly. The data plates contain important product information.
1.Remove logs and heater base assembly from carton. Note: Do not pick up heater base assembly by burners. This could
damage heater. Always handle base assembly by grate.
2.Remove all protective packaging applied to logs and heater for shipment.
3.Check heater for any shipping damage.
If heater is damaged call DESA Heating,
LLC at
Product Features
Operation
This heater is clean burning. It requires no outside venting. There is no heat loss out a vent or up a chimney. Heat is generated by realistic dancing, yellow flames. This heater is designed for vent- free operation with flue damper closed. It has been tested and approved to ANSI Z21.11.2 standard for unvented heaters. State and local codes in some areas prohibit the use of
Safety Pilot
This heater has a pilot with an Oxygen Depletion Sensing (ODS) safety shutoff system. The ODS/pilot is a required feature for
Piezo Ignition System
This heater has a piezo ignitor. This system requires no matches, batteries or other sources to light heater.
www.desatech.com | 5 |