ASSEMBLY
ASSEMBLING HEATER
Tools Required:
•Phillips screwdriver
•5/16" hex wrench
•slotted screwdriver
Removing Front Panel Of Heater
1. Remove two screws near bottom cor- |
ners of front panel with Phillips screw- |
Piezo Ignitor
Ignitor Cable
Figure 3 - Attaching Ignitor Cable to Piezo
Attaching Brass Front Trim to Front Panel
1.Locate brass front trim in brass trim package.
2.Slide the head of two
3.Line up screws with holes in front panel (see Figure 4). Insert screws in holes. Attach nuts from inside of front panel. Tighten with wrench.
driver. |
2. Pull bottom of front panel forward, then |
down (see Figure 2) . |
Ignitor
WARNING: Always have burner shield and screen in place before operating heater. This pre- vents excessive temperatures on heater surfaces.
Failure to position the parts in
Brass Front Trim
Front Panel
Nut |
Figure 2 - Removing Front Panel of Heater
accordance with these diagrams or failure to use only parts spe- cifically approved with this heater may result in property damage or personal injury.
Figure 5 - Attaching Brass Front Trim to Front Panel
Installing Log
Note: For easier installation, lay heater on its back.
1. | Remove log from inside top of heater. |
| Discard protective packaging. |
2. | Attach ignitor cable to piezo ignitor |
| (see Figure 3). |
3. | With Phillips screwdriver, remove four |
| screws holding screen in place. Re- |
| move screen. |
4. | Gently slide log between log retaining |
Log
Screen
Front Panel
Truss Head
Heater Cabinet
Deflector
Log
Retaining
Brackets
brackets on deflector assembly (see Fig- |
ure 4). The log should fit firmly against |
bottom of log retaining brackets. |
5. Reattach screen using four screws re- |
Screw
Nut
Burner Shield
Screw
moved in step 3. |
Brass
Front Trim
Screw
Figure 4 - Assembling Heater
4 | 103509 |