DeWalt 900.370511 instruction manual Grasscatcher Assembly, To Install Grasscatcher

598994-01,370511 TYPE2 1/5/06 10:44 AM Page 6

CAUTION: Do not lift the lawnmower off the ground by holding the height adjustment finger grip.

•Remove the Grasscatcher frame, Grassbag and cardboard fillers.

•Remove the mower from the carton and place all four wheels on the ground or floor.

•Check the carton thoroughly and make sure there are no loose parts.

To Unfold Handle

Raise the handle section into place and secure by tightening the two knobs. See figure below.

WARNING: For your own safety DO NOT use this mower without either the Grasscatcher or Mulch Insert in operating position.

Knobs Handle

GRASSCATCHER ASSEMBLY

•Slide the grassbag onto the grasscatcher frame. (See Fig. A)

•The grassbag has attachment clips sewn around the bag opening.

•Attach the two top clips to the frame, then attach the side clips, and lastly the bottom clip. (See Fig. B)

•Refer to “To Install Grasscatcher” instruction before attaching to mower.

A

B

Clip

TO INSTALL GRASSCATCHER

•Reach down between the mower handle and raise the rear door to a vertical position. (See Fig. A)

•Remove the mulch insert. See page 10 To Remove Mulch Insert.

•Pick up the grasscatcher by the handle and lower the grasscatcher between the lawnmower handles. Position the grass- catcher hanger hooks on the metal rod under the rear door.

(See Fig. B).

•Release the rear door.

WARNING: Never operate the mower unless the hanger hooks on the grasscatcher are seated properly, and the rear discharge door rests firmly against the top of the grasscatcher.

A

6