DeWalt DC730KAR manual Package contents, Description fi g, Electrical safety

ENGLISH

Use only with DEWALT battery packs, others may burst, causing personal injury and damage.

Do not expose to water.

Have defective cords replaced immediately.

Charge only between 4 °C and 40 °C.

Discard the battery pack with due care for the environment.

Do not incinerate the battery pack

NiMH, NiCd+ and Li-Ion.

Charges NiMH and NiCd battery packs.

Charges Li-Ion battery packs.

See technical data for charging time.

Package contents

The package contains:

1Drill/Hammerdrill

2 Battery packs

1Charger

1Kitbox (K version only)

1Instruction manual

1Exploded drawing

NOTE: Battery packs and chargers are not included with N-models.

•Check for damage to the tool, parts or accessories which may have occurred during transport.

•Take the time to thoroughly read and understand this manual prior to operation.

Description (fi g. 1)

WARNING: Never modify the power tool or any part of it. Damage or personal injury could result.

INTENDED USE

These drills/drivers/hammerdrills are designed for professional drilling and screwdriving applications.

DO NOT use under wet conditions or in presence of flammable liquids or gases.

These drills/drivers/hammerdrills are professional power tools. DO NOT let children come into contact with the tool. Supervision is required when inexperienced operators use this tool.

a. Trigger switch

b. Forward/reverse button

c. Torque adjustment collar

d. Gear selector

e.Worklight

f.Keyless chuck

g.Battery pack

h.Battery release buttons

Electrical safety

The electric motor has been designed for one voltage only. Always check that the battery pack voltage corresponds to the voltage on the rating plate. Also make sure that the voltage of your charger corresponds to that of your mains.

Your DEWALT charger is double insulated in accordance with EN 60335; therefore no earth wire is required.

If the supply cord is damaged, it must be replaced by a specially prepared cord available through the DEWALT service organization.

Mains plug replacement (U.K. & Ireland only)

DANGER:

•Should your mains plug need replacing and you are competent to do this, proceed as instructed below. If you are in doubt, contact an authorized DEWALT repair agent or a qualified electrician.

•Disconnect the plug from the supply.

•Cut off the plug and dispose of it safely; a plug with bared copper conductors is dangerous if engaged in a live socket outlet.

•Only fit 13 Amperes BS1363A approved plugs fitted with the correctly rated fuse (1).

•The cable wire colours, or a letter, will be marked at the connection points of most good quality plugs. Attach the wires to their respective

12