ENGLISH
CAUTION: Read and follow all manufacturers' safety warnings for any accessories used with this tool.
CAUTION: To avoid injury, ensure adaptor and accessory are securely tightened.
1.Place the washer (k) on the tool.
2.Place accessory on to washer.
3.Tighten and secure adaptor nut (l) using hex wrench (p).
Attaching the Cut Guide (fig. 7–12)
The depth/cut guide allows you to precisely cut material at a specified depth and more accurately track a marked cut line.
1.Attach the cut guide block (f) by inserting the accessory tabs (m) on the guide into the accessory side mount slots (e) on the main body of the tool.
2.Secure the block to the main body with the supplied screw (o) and washer (u). Tighten with the supplied hex wrench (p).
DEPTH GUIDE
This feature allows you to precisely cut material at a specified depth.
1.Insert the guide arm (g) as shown in figure 8 into the front slot on the guide block (f).
2.Adjust the length of the guide by pulling out or pushing inward to achieve the desired cut depth as shown in figure 9.
3.Secure the guide in place by turning the depth/ cut adjustment knob (n) clockwise. To release the guide turn the depth/cut adjustment knob counterclockwise.
CUT GUIDE
This feature allows you to more accurately track a marked cut line.
1.Insert the guide arm (g) as shown in figure 10 into the slots on the left and right sides of the guide block (f).
2.Adjust the length of the guide by pulling out or pushing inward to achieve the desired length as shown in figure 11.
3.Secure the guide in place by turning the depth/ cut adjustment knob (n) clockwise. To release the guide turn the depth/cut adjustment knob counterclockwise.
NOTE: The guide arm can also be placed in the guard assembly vertically in order to set the height off a cut. Refer to figure 12.
Attaching the Dust Extraction Adaptor (fig. 16)
The Dust Extraction Adaptor allows you to connect the tool to an external dust extractor, either using the AirLock™ system
1.Attach the dust extraction adaptor (q) by inserting the tabs (m) in to the accessory side mount slots (e).
2.Insert screw (o) and washer (u) into the dust extraction adaptor (q) and tighten with the supplied hex key (p).
OPERATION
Instructions for Use (fig. 13, 14)
WARNING: Always observe the safety instructions and applicable regulations.
WARNING: To reduce the risk of serious personal injury, turn tool off and disconnect tool from power source before making any adjustments or removing/installing attachments or accessories.
WARNING: Ensure switch is fully OFF before plugging in the power cord.
1.Plug in power cord.
2.To turn the tool ON, hold it as shown in figure 13 and press the variable speed trigger (a).
NOTE: The further the trigger switch is depressed the faster the tool will operate. If in doubt about the proper speed for your operation, test the performance at low speed and gradually increase until a comfortable speed is found.
3.To turn the tool OFF, release the variable speed trigger (a).
Lock-on Button (fig. 14)
For more comfort in extended use applications, the
LED Worklight (fig. 15)
The LED worklight (b) will activate when the trigger is depressed.
31
