DeWalt DWE46150 Edging Use Application Fig, Maintenance, Replace Brush Skirt Fig

Edging Use Application (Fig. 1)

This concrete grinding shroud has a door feature to allow flush grinding against a wall.

1.Turn off the tool and disconnect from the power source.

2.Using the edging door tab (C), rotate the edging door until it snaps into the open postion.

3.Connect the tool to the power source.

4.Position hands and body away from wheel and door opening.

5.Place the door edge flush to work surface, turn the tool on and begin grinding. Remove the tool from work surface before turning the tool off.

7.When flush grinding is complete, turn off the tool and disconnect from power source. Allow the tool to stop rotating before laying it down.

8.Using the edging door tab (C), rotate door until it snaps into the closed position.

MAINTENANCE

WARNING: To reduce the risk of injury, ALWAYS turn off tool and disconnect the tool from the power source before making any adjustments or removing or installing attachments or accessories. This applies to both the grinder and the dust extractor vacuum. Such preventative safety measures reduce the risk of starting the tool accidentally.

Replace Brush Skirt (Fig. 1)

1.Turn off the tool and disconnect from power source.

2.Push worn brush skirt from brush skirt removal holes (D).

3.Press new brush skirt into brush skirt removal holes until secure. Replacement brush skirts are available at extra cost from your local dealer or authorized service center. If you need assistance in locating

any accessory, please contact DEWALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD 21286, call 1-800-4-DEWALT (1-800- 433-9258) or visit our website: www.dewalt.com.

Cleaning

WARNING: Blow dirt and dust out of all air vents with clean, dry air at least once a week. To minimize the risk of eye injury, always wear ANSI Z87.1 approved eye protection when performing this.

WARNING: Never use solvents or other harsh chemicals for cleaning the non-metallic parts of the tool. These chemicals may weaken the plastic materials used in these parts. Use a cloth dampened only with water and mild soap. Never let any liquid get inside the tool; never immerse any part of the tool into a liquid.

Accessories

WARNING: Since accessories, other than those offered by DEWALT, have not been tested with this product, use of such accessories with this tool could be hazardous. To reduce the risk of injury, only DEWALT recommended accessories should be used with this product.

Recommended accessories for use with your tool are available at extra cost from your local dealer or authorized service center. If you need assistance in locating any accessory, please contact DEWALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD 21286, call 1-800-4-DEWALT (1-800-433-9258) or visit our website: www.dewalt. com.

Repairs

To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment (including brush inspection and replacement) should be performed by a DEWALT factory service center, a DEWALT authorized service center or other qualified service personnel. Always use identical replacement parts.

English

7