DeWalt DWFP12569 Fastener Specifications, Tool AIR Fitting, Operating Pressure, AIR Consumption

DWFP12569_9R202311RA_DWLT_2in1 FLOORING TOOL MANUAL_MAN_JM:103697RevE_MIIIFS_MIIIFN.qxd 2012/9/25 上

DWFP12569 TOOL SPECIFICATIONS

All dimentions in inches unless otherwise specified

MODEL	LENGTH	HEIGHT	WIDTH	WEIGHT
DWFP12569	20.35” (517 mm)	22.08” (561 mm)	3.15” (80 mm)	10.85 lbs (4.9 kg)

FASTENER SPECIFICATIONS:

MODEL	FASTENER	CROWN WIDTH	GAUGE	FASTENER RANGE
DWFP12569	BCS15xx	1/2” (13mm)	15-1/2 Ga., 1/2"	1-1/2" (38mm) to
			Crown Staples	2" (50mm)
DWFP12569	FLN-xxx	-	16 Ga. "L" shape	1-1/2" (38mm) to
			Cleat Nails	2" (50mm)

TOOL AIR FITTING:

This tool uses a 1/4” N.P.T. male plug. The inside diameter should be .200” (5mm) or larger. The fitting must be capable of discharging tool air pressure when disconnected from the air supply.

OPERATING PRESSURE:

70 to 100 p.s.i.g. (4.9 to 7.0 kg/cm²). Select the operating pressure within this range for best fastener performance. DO NOT EXCEED THIS RECOMMENDED OPERATING PRESSURE.

AIR CONSUMPTION:

The DWFP12569 requires 3.7 cubic feet per minute (105 liters per minute) of free air to operate at the rate of 60 fasteners per minute, at 80 p.s.i. (5.6 kg/cm2). Take the actual rate at which the tool will be run to determine the amount of air required. For instance, if your fastener usage averages 30 fasteners per minute, you need 50% of the tool’s c.f.m. of free air which is required to operate the tool at 60 fasteners per minute.

OPERATION

Caution Regarding Use of this Tool to Install Pre-finished Flooring

This DWFP12569 Flooring Tool was designed for use in installing unfinished hardwood flooring. It can be used to install pre-finished flooring however caution must be used to ensure that the finish is not damaged by the tool. It is recommended that the tool be tested on a sample section to be certain that the tool and technique of use do not leave marks on the finish. This procedure should be followed before each job due to variations in flooring and tool condition.

-4-