Mid-Bass Mounting, Screw Clips | Diamond Audio Technology HP650

MOUNTING

Mid-Bass Mounting

The illustration above shows the parts included and correct mounting assembly of the HEX™ Pro component mid-bass drivers. Be sure to check the available mounting depth before installation begins. Use of the foam gasket is recommended to ensure a proper seal between the speaker and mounting surface.

Screw Clips

Gasket

Tweeter Mounting

When mounting the tweeters, make sure desired location can accommodate the hole size, over all diameter and depth required. Cut a hole in the surface chosen and feed speaker wire through. Remove the tweeter mounting ring by unscrewing it counter clockwise. Connect

speaker wire to tweeter terminals and mount speaker

tweeter in hole using provided screws. When tweeter

er in hole

is secure, replace trim ring by screwing it on clockwise. cure, replace

Mid-bass Driver

Mounting Screws