DigiPower TC-2000 Operating instructions, Charging, Cautions, Email cs@digipowersolutions.com

Operating instructions:

1.While the battery is on the cradle, connect the base charger to a power source. The Charging Meter will light up.

The meter will begin to blink at the start of each charging level. Less than 25% capacity, the 1st LED will blink.

Less than 50% capacity, the 2nd LED will blink. Less than 75% capacity, the 3rd LED will blink. Less than 100% capacity, the 4th LED will blink.

When the battery is fully charged, the charging meter will be fully lit and will stop blinking. (The typical charge time is 1-hour for batteries up to 900mAh.)

Base

Charger

Charging
Meter	Battery

Battery

Plate

NOTE:

The charger or battery may become warm when charging. This is a normal occurrence.

CAUTIONS:

Always unplug the charger while not in use.

Do not store, place or use the charger where it may come into contact with water or moisture.

Always replace frayed or damaged wire and broken plugs immediately.

To reduce the risk of electric shock, unplug your charger from the wall outlet before cleaning.

Do not open or disassemble the charger unit.

Maintenance:

Use a clean, DRY cloth when necessary to keep the metal contacts of both the charger and the battery clean.

(Remove from power outlet before cleaning.)

LIMITED WARRANTY:

This product carries a full one-year warranty from date of purchase against defects in materials and workmanship. This warranty does not cover damage resulting from accidents, misuse, unauthorized repair/alternations to the product or failure to follow operating instructions.

Visit our web site: www.digipowersolutions.com

Email: cs@digipowersolutions.com