Dimension One Spas Aurora HP, Architectural Specification, Aurora HP Specifications

2003 Aurora HP Specifications Dimension One Spas

2003 Aurora HP, Architectural Specification

Top View of Spa

THIS 3 FOOT SQUARE AREA,

ON BOTTOM OF SPA, TO BE

SUPPORTED CONSISTENT WITH

THE EDGES OF SPA BASE.

Caution:

Due to manufacturing tolerances there could be some minor differences between the actual spa and the drawing above. If site planni ng is critical t o such tol erances, be sure to measure your actual spa.

Note:

1.Subject to change without notice.

2.Engineering specs may differ slightly from brochure.

3.For E-Z Lifter installation allow 18" clearance on the backside of the spa.

4.Alternative cabinets may add significant weight. Ask your dealer f or exact details.

5.This is the approximate location for drilling a hole if you must bring the power line in through the bottom of the spa. Be careful not to puncture

a plumbing line inside the equipment compar tment (drill from the inside Compartment out)

Doc-538 Rev-C Rev Date: 3/03/03 Specification, 2003, Aurora HP Page 2 of 5