Installation and Operating Instructions
Dimplex Chalbury Fire
Model(s) : CHB20BR & CHB20CH
08/19130/2 Issue 2
Dimensions
(millimetres)
500 | 515 |
Min. |
|
controls | thermostat |
| knob |
| 617 |
| screws |
225 |
50
Fig. 1
THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE.
Important Safety Advice:
When using electrical appliances, Basic precautions should always be followed to reduce the risk of fire, electrical shock, and injury to persons, including the following:
•If the appliance is damaged, check with the supplier before installation and operation.
•Do not use outdoors.
•Do not use in the immediate surroundings of a bath, shower or swimming pool.
•Do not locate the heater immediately below a fixed socket outlet or connection box.
•Do not cover the heater. Do not place material or garments on the heater, or obstruct the air circulation around the heater, for instance by curtains or furniture, as this could cause overheating and a fire risk.
•This appliance is not intended for use by children or other persons without assistance or supervision if their physical, sensory or mental capabilities prevent them from using it safely. Children should be supervised to ensure that they do not play with the appliance.
•Do not use this heater in series with a thermal control, a program controller, a timer or any other device that switches on the heat automatically, since a fire risk exists when the heater is accidentally covered or displaced.
•Ensure that furniture, curtains or other combustible material are positioned no closer than 1 metre from the heater.
•In the event of a fault unplug the heater.
•Unplug the heater when not required for long periods.
•Although this heater complies with safety standards, we do not recommend its use on deep pile carpets or on long hair type of rugs.
•The appliance must be positioned so that the plug is accessible.
•If the supply cord is damaged it must be replaced by the manufacturer or service agent or a similarly qualified person in order to avoid a hazard.
General
Unpack the heater carefully and retain the packaging for possible future use, in the event of moving or returning the fire to your supplier. Loose coals are packed separately within the carton.
The heater is designed for use inset into a 407mm (16") or 457mm (18") wide by 559mm (22") high fireplace opening see also section “Installation in a fire place opening”.
A 2kw fan heater discreetly positioned in the canopy of the fire provides heating in cold weather. Switching allows half or full heat.
Before connecting the heater check that the supply voltage is the same as that stated on the heater.
Electrical
WARNING – THIS APPLIANCE MUST BE EARTHED
This heater must be used on an AC ~ supply only and the voltage marked on the heater must correspond to the supply voltage.
Before switching on, please read the safety warnings and operating instructions.
For your convenience, the heater is fitted with a rewireable plug incorporating a 13 amp fuse. In the event of replacing the fuse in the plug supplied, a 13 amp fuse approved by ASTA to BS1362 must be used.
Installation in a Fireplace Opening
At the rear of the fire, two adjustable supports are provided for levelling the fire where the base of the fireplace opening is raised above the level of the hearth.
Adjust by removing the two screws holding each bracket in position, then refit the bracket and the two screws in the required position.
The metal surround may be removed to allow the fire to be fully inset.
Note: The fire must be positioned a minimum distance of 500mm from a wall as indicated in Fig. 1.
