NOTE
A 15amp, 120 volt alternating current (VAC) circuit is required. A dedicated circuit is preferred but not essential in all cases. A dedicated circuit will be required if, after installation, the circuit breaker trips or fuse blows on a regular basis when the heater is operating. Additional appliances on the same circuit may exceed the current rating of the circuit breaker.
WARNING
Ensure the power cord is not installed so that it is pinched or against a sharp edge and ensure that the power cord is stored or secured to avoid tripping or snagging to reduce the risk of fire, electric shock or injury to persons.
Construction and electrical outlet wiring must comply with local building codes and other applicable regulations to reduce the risk of fire, electric shock and injury to persons.
Do not attempt to wire your own new outlets or circuits. To reduce the risk of fire, electric shock or injury to persons, always use a licensed electrician.
(NO ASSEMBLY REQUIRED FOR THE FLAT WALL MANTEL) CORNER MANTEL ASSEMBLY
1.Assemble the top of the mantel to the rear support using the supplied hardware.
2.Using the supplied hardware assemble the top and rear support assembly to the main fireplace body.
MANTEL
TOP
HARDWARE
OR
REAR
SUPPORT
MAIN BODY
FIREPLACE INSTALLATION
1.Make sure the units MAIN ON/OFF switch is switched OFF (refer to operating instruction section).
2.Plug the unit into a 15Amp/120VAC outlet. If the cord does not reach, you may use a
No. 16 AWG minimum size extension cord rated for a minimum of 1875 watts. | 3 |
|
