RESETTING THE TEMPERATURE CUTOFF SWITCH
Should the heater overheat, an automatic cut out will turn the heater off and it will not come back on without being reset. It can be reset by switching the MAIN ON/OFF SWITCH to OFF and waiting 5 minutes before switching the unit back on.
CAUTION
If you need to continuously reset the heater, unplug the unit and call Dimplex technical support at
NOTE
The heater may emit a slight, harmless odor when first used. This odor is a normal condition caused by initial heating of internal heater parts and will not occur again.
REMOTE OPERATION
The Fireplace is supplied with an integrated on/off remote control
Note: Ensure that the fireplace 3 position switch is set to the remote
Control setting. (Up position)
To operate, push the ON button to turn fireplace on, push the OFF button to turn the fireplace off.
BATTERY REPLACEMENT
To repalce the battery, slide battery cover open on the hand held transmitter. Correctly install one 12 volt (A23) battery in the battery holder.
Close the battery cover.
ON BUTTON | OFF BUTTON |
BATTERY
BATTER COVER
FIGURE 16
6
