DFI2309
REMOTE CONTROL
The remote control has a range of approximately 50ft. (15.25m) it does not have to be pointed at the fireplace and can pass through most obstacles (including walls). It is supplied with one of 243 independent frequencies to prevent interference with other units. The frequency designation is indicated on the back of the transmitter (FIGURE 3)
REMOTE CONTROL INSTALLATION
1.Plug fireplace cordset into the outlet located on the side of the receiver. (FIGURE 2)
2.Plug receiver into the wall outlet.
3.Install a 9 volt battery into the transmitter. (FIGURE 3)
Receiver
Outlet
FIGURE 2
NOTE
•Fireplace MAIN on/off switch must be in the ON position prior to using the Remote Control.
•ON/OFF Remote Control may be used to control most other electrical devices including T.V.’s, stereos and lamps.
CAUTION
•For indoor use in dry areas only
•For use on electrical devices with 15 amp resistive load or 1/3 HP inductive load
•120 volt AC only
OPEN
Frequency
Code
Battery
Cover
FIGURE 3
2
