PARALLEL SYNCED GAIN CONNECTIONS/SETTINGS
1.Input Signal - Connect these RCA jacks as described in the Front Panel Connection section of this guide.
2.Slave/Master Switch
Set the slave/master switch on the master amplifier to the MASTER position.
Set the slave/master switch on the slave amplifier to the SLAVE position.
Setting the slave/master switch on both amplifiers will auto- matically set the I/O RCA jack configuration according to each amplifier’s slave or master designa- tion.
NOTE: | One master amplifier can control up to three slave |
| amplifiers in this combination. Multiple identical |
| master/slave combinations can be added to any |
| given system. |
3.Remote Sub Level Control - Connect the Remote Sub Level Control to the master amplifier only. The master amplifiers subwoofer gain is used to set the overall gain for all synced amplifiers, then the Remote Sub Level Control can adjust the gain of all synced amplifiers.
4.Signal Connection - Connect an RCA cable between the SYNC OUT RCA jack of the master amplifier and the SLAVE IN RCA jack of the slave amplifier as shown in the Figure 5.
5.Subwoofer Speaker Connection - In this amplifier combination each amplifiers must drive its own sepa- rate subwoofer(s). Connect the speaker terminals of each amplifier to any combination of one or more subwoofers that results in nominal impedance between one and four ohms. Make sure that each amplifier sees the same speaker impedance.
© 2003 Directed Electronics, Inc | 13 |
