TRX722-2 transceiver, Lock, Unlock | Directed Electronics AM15

Battery replacement

TRX722-2 transceiver

!Slide the battery compartment door on back of transceiver. (FIG.: 1)

!Once cover as been removed, insert AAA 1.5v battery (Make sure polarity is correct + / -)

!Replace cover and check for operation.

FIG.: 1

Slide the door in this direction

Lift cover

before

slidding

Note: Normal battery life is approximately two years, but can vary depending on use. Change once a year for best performance.

Remote car starter indication

System		Parking lights
System		Parking lights
Remote started		ON
Remote starter normally stop		2 flashes
Engine don’t start		3 flashes
Hood open / Brake		4 flashes
Starting with Service mode activated		5 flashes

TRX722-2 Transceiver’s functions

Lock:

Press one time on this button to lock all doors. The parking light will flash once to confirm and this icon will appear in LCD screen:

Trunk (if applicable and installed)

To open the trunk, press this button for 4 seconds and release. The parking lights will flash 3 times to confirm and this icon will appear in LCD screen:

Unlock:

Press on this button to unlock all doors. The parking lights will flash twice and the dome light will come ON. This icon will appear in LCD screen:

Remote start:

Press once on this button and release. The parking lights will flash to confirm the system received the signal. Parking light will stay ON while engine is running and this icon will appear in LCD screen:

To remote stop the engine:

Press on this same button once and release, the engine will stop. The parking lights will flash twice to confirm.

ICON STATUS REFERENCE CHART

Lock/Unlock	Vibration	Open hood	Open trunk	Open door(s)	Start	Second car	Valet mode Timer Control
Confirmation		detected	detected	detected	successfully	Operation	start

To operate two cars with the same 2way transceiver

While the 2 icon display on the LCD screen, you can remote control and communicate with a second vehicle security system. (if both cars have the same system installed and tranceiver programmed by your installer).

1- Press and hold & buttons at the same time until one long beep is heard. Then, release buttons.

2- Within 5 seconds, press button once & 2 icon will appear on the LCD screen of tranceiver, in the middle of the car. You can now operate the second vehicle previously programmed in your tranceiver.

* To operate car #1, redo steps 1 & 2, and the

icon will disapear.

Vibration mode

It is useful when you are in a noisy place and have difficulty hearing the beep sound from the remote control with the tranceiver in this mode, tranceiver will vibrate if your security system is triggered.

1- Press and hold & buttons at the same time until one long beep is heard. Then, release buttons.

2- Within 5 seconds, press button once & icon will appear on the LCD screen of tranceiver, at the bottom of the car. When an event happens on your vehicle, the tranceiver will vibrate instead of beeping.

* To return to beeping mode, redo steps 1 & 2, and the