Operating the system
SAT radio selection
Press the SAT button to access the Sirius interface. On some radios this button may be labeled as XM or CD/SAT. Pressing this button repeatedly will cycle through sources.
Operation
Use the category control buttons to change a category, if desired.
Use the channel control buttons to change channels. Consecutive presses engage the channel browse mode allowing preview of a channel without tuning. Once the tune button is disengaged channel selection takes place.
Press and hold one of the preset buttons until a beep is heard to save a preset.
To listen to a preset station simply press the desired preset button.
When CATEGORY tune mode is selected the button will cycle through channels only within the current category. The SCAN button previews a station for a few seconds be- fore changing channel to another. Once the desired station is reached press the SCAN again.
Advisory message
“No tuner” - displayed when connection to Sirius tuner or Sirius dock is bad, no tuner is connected or if vehicle ACC power is not cycled once after connecting the
Honda/AcuraDesktop DockingSIRIUS InterfaceStation
interface.
“Connecting” - displayed during the initialization of the Sirius tuner.
“Antenna Error” - displayed when the antenna connection is not detected.
“Acquiring Signal” - displayed while acquiring digital audio stream or when the received signal drops below mini- mum required for tuner to operate.
“Unsubsc. Channel” - displayed when the selected channel is no longer subscribed
“Subscrip. Updated” - displayed when a subscription update received
“Invalid Channel” - indicates that a program became un- available after an update
“Updating XX/100” - indicates Sirius channel map update in progress
“Firmware Update” - indicates an over the air firmware update of the tuner
“Radio id” - on CH000 - shows the Sirius ESN needed for subscription services
The 12 digit Sirius ID is shown alternating: the first 6 digit is followed by a
Portable receivers
You may connect or disconnect portable receivers at any time. Upon connection the “docked portable ” message will replace the “No tuner” followed by “Acquiring Signal” before content becomes available.
© Directed Electronics, all rights reserved.
15
