Directed Electronics OHV800 OONN//OOFFFF CCOONNTTRROOLL, FFUUNNCCTTIIOONN MMOODDEE ((MMEENNUU)), DDOOOORR LLIIGGHHTT OONN//OOFFFF

SSIIGGNNAALL SSOOUURRCCEE SSEELLEECCTTIIOONN

Select the input signal for viewing (AV1 or AV2) by momentarily pressing the MODE

button ( ) on the LCD screen or the MODE button on the remote.

OONN//OOFFFF CCOONNTTRROOLL

Press and hold the ( ) button on the LCD screen or momentarily press the POWER

button on the remote.

FFUUNNCCTTIIOONN MMOODDEE ((MMEENNUU))

Press the MENU button on either the LCD screen or the remote to display the fol-

lowing setup options: COLOR

CONTRAST

BRIGHTNESS

TINT

RESET (restore factory default settings)

Use the MENU button on the LCD screen or use the MENU button (or the ∧∧/∨∨ but-

tons) on the remote to scroll through the menu options. Once the desired setting

is selected use the UP/DOWN buttons on the LCD screen or the >>/<< buttons on

the remote to change the setting. After 5-seconds of inactivity the MENU screen

will turn off.

DDOOOORR LLIIGGHHTT OONN//OOFFFF

Press this switch on the LCD screen to have the door open sensor operate the dome

lights.

NNOOTTEE::This feature is operational only if the Gray or Purple door lock trigger wires have been

connected to the door sensor.

The dome light selector switch contains two separate circuits. One for a positive

dome light trigger and one for a negative dome light trigger. Please refer to the

wiring table below for each of these triggers.