Dirt Devil CV2600 operating instructions Models CV1800, CV2200

Dirt Devil® Filtered Cyclonic

MODELS: CV1800, CV2200

	2) Remove the cyclonic cone by
	pulling down on it. Place cone
	in dirt canister.
	3) Remove the pleated filter by
	turning the filter latch 90˚ (counter-
	clockwise) to disengage the filter.
	(The filter latch is located at the
	bottom of the pleated filter)
ILLUS. #1	4) Insert new pleated filter (p/n
	8106-01) and engage filter latch
	(by rotating it 90˚ clockwise until
Follow these steps to empty the dirt	you feel it snap in place).
canister (refer to Illustration #1)	5) Raise the dirt canister (with cone
Make sure the Power Unit is OFF.	inside) to the proper location
	under the power unit and engage
1) Disengage the canister latches
	the latches.
located on opposite sides of the
	6) Be certain the dirt canister and
power unit.
	cyclonic cone seal are “seated”
2) Remove the dirt canister.
	properly to the body of the unit.
3) Dispose of canister contents in
trash receptacle.
4) Raise the empty dirt canister to the
proper location under the power	Filter
unit and engage the latches.
	Cartridge
5) Be certain the dirt canister and
the cyclonic cone seal are
“seated” properly to the body of
the unit.	Cyclonic
	Cone Seal
Follow these steps to replace the
filter cartridge (refer to Illustration #2)
Make sure the Power Unit is OFF.
1) Unlatch and remove the Dirt		Filter Latch
Canister.	Cyclonic Cone
		(turn 90° to
		disengage filter)
	Dirt Canister
	ILLUS. #2