The messages shown below display your systems condition.
EJECT: No disc magazine has been loaded in
the changer. The disc magazine is not
completely loaded.
➪ Load the disc magazine properly.
No CD in the unit.
➪ Insert the CD.
No Disc: No disc has been loaded in the disc
magazine.
➪ Load a disc into the disc magazine.
TOC Error: No disc has been loaded in the disc
magazine.
➪ Load a disc into the disc magazine.
The CD is quite dirty. The CD is upside-
down. The CD is scratched a lot.
➪ Clean the CD and load it correctly.
E-05: The CD is upside-down.
➪ Load the CD correctly.
Blank Disc: Nothing has been recorded on the MD.
No Track: No tracks are recorded on the MD,
although it has a title.
E-15: Media was played that doesn’t have data
recorded that the unit can play.
➪ Use media that has data recorded that
the unit can play.
No Panel: The faceplate of the slave unit being
connected to this unit has been removed.
➪ Replace it.
E-77: The unit is malfunctioning for some reason.
➪ Press the reset button on the unit. If the
"E-77" code does not disappear, consult
your nearest service center.
Mecha Error: Something is wrong with the disc
magazine. Or the unit is malfunctioning for
some reason.
➪ Check the disc magazine. And then
press the reset button on the unit. If the
"Mecha Error" code does not disappear,
consult your nearest service center.
Hold Error: The protective circuit in the unit activates
when the temperature inside the
automatic disc changer exceeds 60°C
(140°F), stopping all operation.
➪ Cool down the unit by opening
the windows or turning on the air
conditioner. As the temperature falls
below 60°C (140°F), the disc will start
playing again.
NO NAME: • Attempted to display DNPS during the CD
play having no disc names preset.
• Attempted to display the ID3 tag while
the MP3/WMA having no ID3 tag is being
played.
Waiting: Radio text data is being received.
Load: Discs are being exchanged in the Disc
changer.
Reading: The unit is reading the data on the disc.
NO ACCESS: After setting it in the Disc Changer, DNPP
was done without having it been played at
least 1 time.
IN (Blink): The CD player section is not operating
properly.
➪ Reinsert the CD. If the CD cannot be
ejected or the display continues to flash
even when the CD has been properly
reinserted, please switch off the power
and consult your nearest service center.
Unsupported File:
A MP3/WMA is played with a format that
this unit can’t support.
➪ ----
Protected File: A copy-protected file is played.
➪ ----
Demo Mode: The Demonstration mode has been
selected.
➪ Hold down button [5] and press
the Reset button to release the
Demonstration mode.
English | 45