Dixon 13639-0702, 2003 manual Specifications, ZTR Classic

	SPECIFICATIONS
	ZTR Classic
CHASSIS:	11 GA welded rectangular tubing
BODY:	All body parts made of high density polyethylene. Dent
	and corrosion resistant. Front body contains access
	panel for battery service.
MOWER DECK:	13 GA stamped steel construction. Three blades
	combine for a 42” cut width. Cut height approximately
	1”- 4” via 7-position lift handle.
BLADE DRIVE:	Electric clutch.
TRANSMISSION:	Each rear wheel is independently driven by chain and
	sprockets through a mechanical friction drive.
ENGINE:	14.5 HP Briggs & Stratton Intek, 4-Cycle, Single Cylinder,
	Overhead Valve, Air-Cooled, Gasoline, Vertical Shaft with
	Cast Iron Cylinder, AVS (Anti-Vibration System), Pressure
	Lube & Filter.
STARTING SYSTEM:	Electric by key switch operation with safety interlock
	blade drive.
TIRES:	Front	11 x 4.00-5 ribbed tread.
	Rear	18 x 8.50-8 Turf Trac R/S
RECOMMENDED	Front	16-21 PSI
TIRE PRESSURE:	Rear	8-14 PSI
CAPACITIES:	Fuel	2.4 gallons total
	Engine	1.5 quarts oil
DIMENSIONS:	Width	47” outside rear wheel measurement
	Height	42” to top edge of seat
	Length	72” hitch tab to front bumper
	Weight	520 lbs.

Additional information provided in service instructions under the individual component.

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE

13