TECHNICAL DATA BROCHURE - ZTR 428 & 429
DATE 8/89 (Rev.)
PAGE 1 of 11
MPORTANT
Deluxe Seat Adjustment
Easy hand lever action allows forward and backward movement, of seat. No bolts to loosen or tighten.
Mower Blade Operation
1.To start mower blades, pull up slightly on blade drive switch handle and move it forward to the "ON" position.
2.To stop mower blades, move switch handle to the "OFF" position.
Body Removal
1.Disconnect throttle cable from engine.
2.Disconnect rear wiring loon from the
3.Remove the four control lever bolts and remove upper control levers (P/N 9079 A 9080).
4.Remove the two acorn nuts on floor of body and release latches on the rear of body near each side.
5.Place height adjustment lever in the vertical position, engage the
parking brake and carefully l i f t body off the chassis.
6.Reverse above procedures to install body.
Safety Checks
1.After reassembly of body onto chassis and while seated on the mower, attempt to start the engine with mower deck engaged. The engine should not start. If engine does start, return mower to an Authorized Dixon Dealer for adjustment or repair.
2.Disengage mower deck and start engine with the operator in a normal seated position on the mower. Engage mower deck and remove weight from the seat. The engine should stop. If engine does not stop when operator rises from seat, return mower to an Authorized Dixon Dealer for adjustment or repair.
Parking Brake Adjustment
1.Remove body as described above.
2 . | Adjustment points | are located at rear of transaxle on | each side. | |
| Remove roll pins | from swivel fitting (P/N 2172). Turn | swivel fitting on | |
| brake rod (P/N 6100) in, to | tighten. Just enough to prevent brake from | ||
| slipping when engaged. 3. | Reinstall roll pin. |
| |
CAUTION: Over tightening may cause premature wear, on bra ke band (P/N 6085).
Dixon Industries, INC.
Box 1569 | Coffeyville, Kansas | Airport Industrial Park |
TELEX: 417109
