8
SR Series EQ’s
ATTENTION: DO NOT USE BOTH THE BALANCED AND UNBALANCED INPUT/OUTPUT JACKS TO A CHANNEL AT THE SAME TIME. Using more than one connector at a time for the input/output pair can unbalance balanced lines, cause phase cancellation, short a conductor to ground, or cause damage to other equipment connected to the equalizer.
Maintenance and service
Other than keeping the unit clean and occasionally checking the connectors and cables to the unit for integrity, there is no maintenance necessary for DOD equalizers.
There are NO user serviceable parts inside the units. Opening the chassis will void the warranty. All service and repair must be performed by the factory or an authorized service center for the warranty to remain in service.
Should a problem arise with the equalizer, please contact your authorized DOD Electronics dealer for return/repair procedures.
Specifications
Frequency Response: 20Hz to 20kHz,
Low Cut Filter: 12 dB/ octave
Frequency Center Tolerance: 5%
Control Range: 12 dB cut/ boost
Recommended Operating Level:
Input Impedance: 40k Ω balanced, 20k Ω unbalanced
Maximum Output Level: +21 dBu (balanced or unbalanced)
Input Level Control:
Input Level Indicator: LED bar graph;
Harmonic Distortion: .006% @ 1 kHz
S/N Ratio: Greater than 90 dB (ref. 0.0775Vrms)
Electronic Switching: In/Out and Filter switches (FET type)
Power Requirements:
Dimensions 430 and 431: 1.75”x6”x19”
Dimensions 231, 830, and 831: 3.5”x6”x19”
