10
6
7
8
Installing the cutter guard
Cutting tool Cutter guard
Tool/guard combinations for the MS-260 U / MS-330 U / MS-430 U
A
4-tooth star blade: Part no. 362 224 140 Part no. 351 504 101
Outside diameter: 230 mm (9"), arbour: 25,4 mm (1")
2-line trimmer head Part no. 351 502 030 Part no. 351 504 101
15 m Part no. 369 224 070 and
120 m Part no. 369 224 072 Part no. 351 504 102
Install the guard extension
Mounting the cutter guard
- Hook the hood (A/5) by the cutout (A/1) on the lug (A/2).
- Insert and tighten bolt (A/3) and nut (A/4).
Important: Safety regulations and your own safety make
it imperative to use the right cutter guard with a given
cutting tool!
Warning: Use only the cutting tools shown here! It is not
permitted to use other cutting tools as this can increase dan-
ger of accidents and cause damage to the equipment!
B
Mounting the guard extension for use with trimmer head.
- See above for installation of the cutter guard.
- Attach the guard extension (B/6) supplied with the brushcut-
ter to the upper part of the cutter guard (A/5), bending it to
tthecontouroftheguard.
- Attach the trimmer line knife (B/7) to the guard extension
(B/8) with the bolt (B/6).
Note: If the trimmer line has been extended (see “Adjusting
theline”)thetrimmerlineknifeautomaticallycutstheline
ends to the same length during use.
Cutting tool Cutter guard
Tool/guard combinations for the MS-230 C / MS-260 C / MS-330 C
2-line trimmer head Part no. 351 502 030 Part no. 351 504 101
15 m Part no. 369 224 070 and
120 m Part no. 369 224 072 Part no. 351 504 102
Install the guard extension