32
Instructions for daily and periodic maintenance
To ensure long life, prevent damage and ensure the full functioning of the safety features the following maintenance must be performed
regularly. Guarantee claims can be recognized only if this work is performed regularly and properly. Failure to perform the prescribed
maintenance work can lead to accidents!
Perform the following servicing work daily after use. Make a habit of it, it does not require much time and your saw will always function
properly.
Possibly hidden faults can be detected in this manner before causing expensive and annoying interruptions of your work. In case
you should detect a fault in the safety equipment when performing daily servicing, the saw must not be used before elimination of
the fault.
The user of the chain saw must not perform maintenance work which is not described in the instruction manual. All such work must
be carried out by a DOLMAR service center.
General Chain saw Clean exterior, check for damage. In case of damage,
have repaired by a qualied service center immediately
Saw chain Sharpen regulary, replace in good time 27-28
Chain brake Have inspected regularly at an authorized service center
Guide bar Turn over to ensure even wear of bearing surfaces
Replace in good time 21, 29
Starter cable Check for damage. In case of damage,
have repaired by a qualied service center immediately
Spark arrester screen Inspect for damage, clean if clogged 31
Before each start Saw chain Inspect for damage and sharpness 27-28
Check chain tension 21
Guide bar Check for damage
Chain lubrication Functional check 24
Chain brake Functional check 26
Combination switch,
Throttle stopper,
Throttle lever Functional check 25
Fuel/oil tank plug Check for tightness and lekages
Every day Air lter Clean (more often if necessary) 30
Guide bar Check for damage, clean oil intake bore 29
Guide bar support Clean, in particular the oil guide groove 29
Idle speed Check (chain must not run) 26-27
Every week Fan housing Clean to ensure proper air cooling 17
Spark plug Check and replace if necessary 31
Mufer Check tightness of mounting 31
Chain catch Check 17
Screws and nuts Check their condition and that they are rmly secured.
Every 3 months Fuel lter Replace 30
Fuel, oil tanks Clean
Annually Chain saw Check at an authorized service center
Storage Chain saw Clean exterior, check for damage. In case of damage,
have repaired by a qualied service center immediately
Chain, guide bar Demount, clean and oil slightly
Clean the guide groove of the guide bar 29
Fuel, oil tanks Empty and clean
Carburetor Run empty
Page
Service, spare parts and guarantee
Maintenance and repair
The maintenance and repair of modern engines as well as all safety devices require qualied technical training and a special work-
shop equipped with special tools and testing devices.
We therefore recommend that you consult a DOLMAR service center for all work not described in this instruction manual. The
DOLMAR service centers have all the necessary equipment and skilled and experienced personnel, who can work out cost-effective
solutions and advise you in all matters.
Please contact your nearest service center. Should you however not have an adress for a DOLMAR service center then please
contact the DOLMAR general trading company (see last page) who will gladly provide you with the adress of your nearest DOLMAR
service center.