DM 2610934164 05-06 10/6/06 8:41 AM Page 8

Cutting Guide Installation

The cutting guide 565 (sold separately) comes completely assembled and ready to use. For use in a variety of materials up to 19,1mm thick. Match the bit type to material to be cut. Always hold the tool firmly, using slow steady pressure to make cuts.

To attach, follow the four steps shown below.

FIG. 1

Important: When viewing the tool from the top, the bit rotates clockwise. Feed direction of cutting must be counter-clockwise.

FIG. 2

FIG. 3

FIG. 4

43/

2/1

41/

0

Operating Instructions for Cutting Guide

Attachment

#560

Drywall Cutting Bit

For use in drywall.

When inserting the #560 bit into your MultiPro tool, make sure that the bit has been inserted as far as possible.

When making freehand cuts in drywall, example repairing a hole in drywall, use the Multipurpose bit #561,cutting in a clockwise direction. When using a template (outlet box) behind the drywall, use the drywall bit #560, cutting in a counter-clockwise direction.

#561

Multipurpose Cutting Bit

For use in wood, plastics, drywall, fiberglass, vinyl or aluminum siding, acoustical tile and laminates.

When inserting the #561 bit into your MultiPro tool, make sure that the bit has been inserted as far as possible.

When making freehand cuts in Drywall, example repairing a hole in drywall, use the Multipurpose bit

#561, cutting in a clockwise direction. When using a template (outlet box) behind the drywall, use the drywall bit #560, cutting in a counter-clockwise direction.

When using #561, Multipurpose Cutting Bit, and #562, Tile Cutting Bit, start the bit into the material at a 45 degree angle and then slowly bring it to a 90 degree angle to begin the cut.

#562

Tile Cutting Bit

For use on wall tile, cement board and plaster

When inserting the #562 bit into your MultiPro tool, it is very important that 1,6mm-3,2mm of smooth shank remains visible above the collet.

When using #561, Multipurpose Cutting Bit, and #562, Tile Cutting Bit, start the bit into the material at a 45 degree angle and then slowly bring it to a 90 degree angle to begin the cut.

NOT FOR USE ON FLOOR TILE

Page 8

Page 8
Image 8
Dremel 398-49 Operating Instructions for Cutting Guide Attachment, Cutting Guide Installation, For use in drywall