commode assembly
instructions and precautions
Seat Clamps
FIGURE 1
MAX WEIGHT: 850 LBS
assembling commode
seat and lid:
1.Before assembling, allow toilet seat and lid to reach room temperature if exposed to cold. This will help prevent the seat and lid clamps from cracking while being assembled onto commode back frame rail.
2.Align the toilet seat clamps onto the back frame rail. (Both clamps should sit outside the pail brackets.) Push down on seat until clamps snap firmly into place.
3.Slide pail in from front of commode.
additional precautions:
1.Toilet seat must be in down position before use. Failure to do so may result in breakage of commode and possible injury.
2.Do NOT install commode without first reading and understanding this assembly and instruction sheet. If you can not understand these instructions, contact a healthcare, dealer or technical professional before attempting to install. Otherwise, injury or damage may occur.
3.Inspect all parts for shipping damage
before assembly. If there is shipping damage - DO NOT USE. Contact dealer/carrier for further instructions.
4.Ensure ALL screws, nuts and/or bolts are tightened.
5.Check the rubber tips on the leg extensions for rips, wear or if they are are missing. Immediately replace any or all if any of these imperfections exist.
6.All four leg extensions with rubber tips MUST touch the floor simultaneously at all times.
7.Users with limited physical strength should be supervised or assisted while using commode.
8.Use the arm supports only for assistance. DO NOT attempt to use the arms to support full body weight.
9.Arms should be unlatched and dropped to assist in transfer onto/off the device.
