8
set up & operation4. Place the patient tubing to the appropriate position of patient and start to suck sputum.
5. When the sputum reaches the safe full level of collection bole (800 cc), the suctioning will
stop sucking automatically (float shut-off).
6. Switch the power switch to “O” position (off), shut off the suction motor.
7. Remove the sputum from collection bole aer the motor stops turning completely. (Please
refer to the section “CLEAN INSTRUCTIONS” on page 9 for the directions of how to clean the
collection bole).
8. Turn on the unit and start to run the suction unit again.
NOTE
1. If the unit sustains a severe drop, validity of the gauge must be checked. Inspect if the float
shut-off is still functioning properly when the liquid in the collection bole reaches the safe full
level.
2. Always transport unit with vacuum adjust knob rotated fully clockwise in case unit is dropped.
CAUTION
1. When automatic float shut-off is activated, contents of the collection boles should be emp-
tied. Further suctioning could cause damage to the vacuum pump.
2. Should fluid be aspirated back into the unit, send your suction to an authorized service center
for a detailed inspection as the vacuum pump may have been damaged.
Clean Collection Bole:
1. Turn off the suction unit and allow vacuum to drop, then disconnect AC power source.
2. With the collection bole still in the holder, remove the collection bole lid. The bole can now
be taken out of the holder to be emptied.
NOTE
Collection bole should be emptied aer each use.
3. Collection bole should be thoroughly cleaned aer each use by one of the following three
methods:
a. Wash in a hot water/dishwashing detergent solution and rinse with clean, hot tap water. Then
wash in one part vinegar to three parts hot water solution. Rinse with hot tap water and air
dry.
b. Wash with rubbing alcohol and air dry
c. Wash with a commercial (bacterial-germicidal) disinfectant, follow disinfectant manufacturer’s
recommended instructions and dilution rates carefully.
!
!
cleaning!