Dual XDMA7650 owner manual General Operation, Power On/Off Source Auxiliary Input

XDMA7650 OPERATION

General Operation

Power On/Off

Source

Auxiliary Input

Steering Wheel Interface Input

Volume

Display

Reset

Set the Clock

12/24-hour Clock

Press or any other button (except EJECT or OPEN) to turn the unit on. Press and hold for 3 seconds to turn the unit off.

Press SOURCE to select between AM/FM, CD player, USB, operation of iPod and auxiliary input. Modes of operation are shown in the display.

Note: CD, USB and operation of iPod modes will not appear unless a CD is inserted or USB/iPod devices are connected.

Insert a 3.5mm connector into the front panel AUX port. Connect the other end of the 3.5mm connector to the headphone output of an audio device, MP3 player, etc. Press SOURCE to select AUX mode.

The steering wheel interface input located on the back of the head unit allows connection to the Pacific Accessory Corporation (PAC) SWI-PSinterface module (sold separately). Visit www.pac-audio.com for details.

To configure steering wheel controls, follow the instructions provided with the PAC SWI-PSinterface module. After installing the interface module, insert the module's 3.5mm jack into the port on the back of the head unit.

Adjust volume using volume knob (00-46).

Press DISPLAY to select between clock and different types of information, such as radio frequency, CD track/elapsed time or MP3/WMA song information.

Press RESET upon initial installation or if abnormal operation occurs. Reset button is located on the front panel.

With the unit on, press and hold DISPLAY until the clock begins to flash, then release. Press TUNE nnto adjust the hours and TUNE llto adjust the minutes. Press DISPLAY momentarily to save the selected time.

The clock will display 12-hour AM/PM time in USA frequency spacing mode (PM 10:00). In European frequency spacing mode, the clock will display 24-hour time (22:00).

6