XIA3145 INSTALLATION
Connection Descriptions
NOTE: Be sure to follow specific instructions included with your amplifier installation kit (not included with this amplifier). The information below should be used a general guideline only.
Power Wire (+12V)
•Disconnect negative battery terminal before proceeding. Consult a qualified technician for instructions if you are unsure.
•Plan wire routing before cutting any wires to length. Begin by routing the power +12V wire from the battery to the amplifier location. Use a grommet when running wires through the firewall or metal openings. Avoid running the power wire near existing vehicle wiring to prevent induced noise from entering the audio system.
•Use extreme caution when drilling holes to avoid damaging fuel lines or existing vehicle wiring.
•The +12V wire MUST be fused within 18" of the battery for protection of the vehicle’s electrical system.
Ground Wire (GND)
•The amplifier ground wire should be as short as possible. Choose a clean unpainted section of metal or the vehicle chassis when attaching the ground connection.
Be sure to clean the area of any dirt or grease.
Remote Turn-on Wire (REM)
•The remote
Speaker Wires
•Choose adequate gauge speaker wire depending on your exact amplifier/speaker combination. Be sure to observe polarity when connecting.
•Do not ground any speaker wires or connect any speaker wires together.
Illuminite Circuit (12VDC Output - for DUAL illuminite speakers only)
•Use
•Do not ground any illuminite output wires or connect any illuminite wires together.
Input Signal
•The amplifier's input signal connects to the head unit's low level (RCA) or high level (speaker wire) outputs.
•Low level input signal deliver the best performance. If unavailable, use the high level inputs - when interfacing with factory head unit for instance.
CAUTION
•Do not use both low and high level inputs at the same time - connect only one or the other.
3
